This is the first step in deprecating omap_hsmmc driver completely and moving to sdhci-omap driver which uses the sdhci library. This patch that adds a new SDHCI quirk "MMC_RSP_136" has already been merged and hence removed it in this revision. Apart from the quirk, sdhci-omap has it's own callbacks to set_clock (clock divider programming is different from generic sdhci) , set_power, set_bus_width, set_bus_mode and platform_send_init_74_clocks. These callback functions are implemented based on omap_hsmmc driver. Since sdhci-omap driver requires pbias regulator fixes to be present, I've sent them as part of this series. The sdhci-omap driver supports only the high speed mode and UHS/HS200 mode will be added in a later series. It has been tested only in boards having DRA7 SoCs like dra7-evm, dra72-evm, am571x-idk, am572x-idk, am57xx-evm. (Tested only eMMC and SD. SDIO support will be added later). The plan is to fully convert DRA7 SoC to use SDHCI driver and then convert other legacy platforms to use SDHCI. The first 3 patches have also been verified not to cause any regression. Next Steps: *) Add UHS support to sdhci-omap *) Add SDIO support *) Add support for older TI platforms Changes from v2: *) Rebased on git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc.git next *) Included a couple of patches from Ravikumar to fix pbias-regulator driver to support max-voltage of 3.3V. This is required for sdhci-omap driver. *) Create sdhci-omap as a new driver with MMC generic bindings and hence doesn't have bindings like ti,dual-volt added for omap-hsmmc. (Instead of ti,dual-volt, sdhci-omap driver uses the supported regulator voltage to set controller IO voltage capabilities). When omap-hsmmc driver is deprecated, support for these properties will be added to sdhci-omap. *) Fixed minor comments from Adrian). Changes from v1: *) Remove the quirks and instead use sdhci_omap specific callbacks for set_power, set_busmode etc. *) Add a patch from Adrian to tidy reading 136-bit responses I've also pushed the entire series along with dependent dt patches @ https://github.com/kishon/linux-wip.git ulf_next (in case someone wants to test) Kishon Vijay Abraham I (4): mmc: host: omap_hsmmc: Remove setting PBIAS voltage dt-bindings: sdhci-omap: Add bindings for the sdhci-omap controller mmc: sdhci-omap: Add OMAP SDHCI driver MAINTAINERS: Add TI OMAP SDHCI Maintainer Ravikumar Kattekola (2): regulator: pbias: Select voltage table based on max-voltage ARM: dts: dra7: Increase max-voltage of pbias regulator .../devicetree/bindings/mmc/sdhci-omap.txt | 16 + MAINTAINERS | 6 + arch/arm/boot/dts/dra7.dtsi | 2 +- drivers/mmc/host/Kconfig | 12 + drivers/mmc/host/Makefile | 1 + drivers/mmc/host/omap_hsmmc.c | 33 +- drivers/mmc/host/sdhci-omap.c | 604 +++++++++++++++++++++ drivers/regulator/pbias-regulator.c | 21 +- 8 files changed, 666 insertions(+), 29 deletions(-) create mode 100644 Documentation/devicetree/bindings/mmc/sdhci-omap.txt create mode 100644 drivers/mmc/host/sdhci-omap.c -- 2.11.0 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
