On 04/21/2017 03:15 PM, Roger Quadros wrote:
> diff --git a/Documentation/devicetree/bindings/net/mdio.txt b/Documentation/devicetree/bindings/net/mdio.txt
> new file mode 100644
> index 0000000..4ffbbac
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/net/mdio.txt
> @@ -0,0 +1,33 @@
> +Common MDIO bus properties.
> +
> +These are generic properties that can apply to any MDIO bus.
> +
> +Optional properties:
> +- reset-gpios: List of one or more GPIOs that control the RESET lines
> + of the PHYs on that MDIO bus.
> +- reset-delay-us: RESET pulse width in microseconds as per PHY datasheet.
> +
> +A list of child nodes, one per device on the bus is expected. These
> +should follow the generic phy.txt, or a device specific binding document.
> +
> +Example :
> +This example shows these optional properties, plus other properties
> +required for the TI Davinci MDIO driver.
> +
> + davinci_mdio: ethernet@0x5c030000 {
> + compatible = "ti,davinci_mdio";
> + reg = <0x5c030000 0x1000>;
> + #address-cells = <1>;
> + #size-cells = <0>;
> +
> + reset-gpios = <&gpio2 5 GPIO_ACTIVE_LOW>;
> + reset-delay-us = <2>; /* PHY datasheet states 1us min */
If this is the reset line of the PHY shouldn't it be a property of the PHY
node rather than of the MDIO controller node (which might have a reset on
its own)?
> +
> + ethphy0: ethernet-phy@1 {
> + reg = <1>;
> + };
> +
> + ethphy1: ethernet-phy@3 {
> + reg = <3>;
> + };
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
