On Thu, May 07, 2009 at 11:01:35PM +0800, stanley.miao wrote: > Hi, Tony, > > Now the kernel can't boot on LDP. The attached file is the boot log. No boot log found. My master branch, based upon 2.6.29-rc3 boots fine on the LDP. Uncompressing Linux............................................................. ............................................ done, booting the kernel. Linux version 2.6.29-rc3 (rmk@xxxxxxxxxxxxxxxxxxxxxxx) (gcc version 4.3.2 (GCC)) #125 Mon Feb 2 22:22:54 GMT 2009 CPU: ARMv7 Processor [411fc082] revision 2 (ARMv7), cr=10c5387f CPU: VIPT nonaliasing data cache, VIPT nonaliasing instruction cache Machine: OMAP LDP board Memory policy: ECC disabled, Data cache writeback OMAP3430 ES2.1 SRAM: Mapped pa 0x40200000 to va 0xd7000000 size: 0x100000 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32512 Kernel command line: console=ttyS2,115200n8 noinitrd mem=128M root=/dev/mmcblk0p2 rw ip=none rootdelay=2 video=omap24xxfb:rotation=270 Clocking rate (Crystal/DPLL/ARM core): 26.0/266/500 MHz GPMC revision 5.0 IRQ: Found an INTC at 0xd8200000 (revision 4.0) with 96 interrupts Total of 96 interrupts on 1 active controller OMAP34xx GPIO hardware version 2.5 PID hash table entries: 512 (order: 9, 2048 bytes) Console: colour dummy device 80x30 Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Memory: 128MB = 128MB total Memory: 126292KB available (2964K code, 372K data, 120K init) Calibrating delay loop... 498.87 BogoMIPS (lpj=1945600) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok net_namespace: 296 bytes NET: Registered protocol family 16 OMAP DMA hardware revision 4.0 USB: No board-specific platform config found bio: create slab <bio-0> at 0 SCSI subsystem initialized i2c_omap i2c_omap.1: bus 1 rev3.12 at 2600 kHz twl4030: PIH (irq 7) chaining IRQs 368..375 twl4030: power (irq 373) chaining IRQs 376..383 twl4030: gpio (irq 368) chaining IRQs 384..401 i2c_omap i2c_omap.2: bus 2 rev3.12 at 400 kHz i2c_omap i2c_omap.3: bus 3 rev3.12 at 400 kHz NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 4096 (order: 3, 32768 bytes) TCP bind hash table entries: 4096 (order: 2, 16384 bytes) TCP: Hash tables configured (established 4096 bind 4096) TCP reno registered NET: Registered protocol family 1 NetWinder Floating Point Emulator V0.97 (double precision) VFS: Disk quotas dquot_6.5.2 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) msgmni has been set to 246 io scheduler noop registered io scheduler anticipatory registered (default) io scheduler deadline registered io scheduler cfq registered omapfb: configured for panel ldp omapfb: DISPC version 3.0 initialized omapfb: Framebuffer initialized. Total vram 614400 planes 1 omapfb: Pixclock 32000 kHz hfreq 60.3 kHz vfreq 93.7 Hz Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled serial8250.0: ttyS0 at MMIO 0x4806a000 (irq = 72) is a ST16654 serial8250.0: ttyS1 at MMIO 0x4806c000 (irq = 73) is a ST16654 serial8250.0: ttyS2 at MMIO 0x49020000 (irq = 74) is a ST16654 console [ttyS2] enabled brd: module loaded loop: module loaded smsc911x: Driver version 2008-10-21. smsc911x-mdio: probed eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=ffffffff:01, irq=-1) net eth0: MAC Address: 00:08:ee:02:24:b2 Driver 'sd' needs updating - please use bus_type methods twl4030_rtc twl4030_rtc: rtc core: registered twl4030_rtc as rtc0 twl4030_rtc twl4030_rtc: Power up reset detected. twl4030_rtc twl4030_rtc: Enabling TWL4030-RTC. i2c /dev entries driver Driver for 1-wire Dallas network protocol. OMAP Watchdog Timer Rev 0x31: initial timeout 60 sec mmci-omap-hs mmci-omap-hs.0: Failed to get debounce clock Advanced Linux Sound Architecture Driver Version 1.0.18a. No device for DAI AD73311 No device for DAI AK4535 No device for DAI CS4270 No device for DAI PCM3008 HiFi No device for DAI SSM2602 No device for DAI tlv320aic23 No device for DAI tlv320aic3x No device for DAI twl4030 No device for DAI UDA134X No device for DAI UDA1380 No device for DAI UDA1380 No device for DAI UDA1380 No device for DAI WM8510 HiFi No device for DAI WM8580 PAIFRX No device for DAI WM8580 PAIFTX No device for DAI WM8728 No device for DAI WM8731 No device for DAI WM8750 No device for DAI WM8971 No device for DAI WM8990 ADC/DAC Primary ALSA device list: No soundcards found. TCP cubic registered NET: Registered protocol family 17 RPC: Registered udp transport module. RPC: Registered tcp transport module. VFP support v0.3: implementor 41 architecture 3 part 30 variant c rev 1 twl4030_rtc twl4030_rtc: setting system clock to 2000-01-01 00:00:00 UTC (946684800) Waiting 2sec before mounting root device... mmc0: host does not support reading read-only switch. assuming write-enable. mmc0: new high speed SD card at address 0002 mmcblk0: mmc0:0002 00000 971 MiB mmcblk0: p1 p2 kjournald starting. Commit interval 5 seconds EXT3-fs warning: mounting fs with errors, running e2fsck is recommended EXT3 FS on mmcblk0p2, internal journal EXT3-fs: recovery complete. EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) on device 179:2. Freeing init memory: 120K INIT: version 2.86 booting .udev/ already exists on the static /dev! Starting the hotplug events dispatcher udevd Synthesizing the initial hotplug events ... -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
