* Lee Jones <lee.jones@xxxxxxxxxx> [170103 08:32]:
> On Mon, 05 Dec 2016, Tony Lindgren wrote:
> > +static int cpcap_init_irq_chip(struct cpcap_ddata *cpcap, int irq_chip,
> > + int irq_start, int nr_irqs)
> > +{
> > + struct regmap_irq_chip *chip = &cpcap_irq_chip[irq_chip];
> > + int i, ret;
> > +
> > + for (i = irq_start; i < irq_start + nr_irqs; i++) {
> > + struct regmap_irq *cpcap_irq = &cpcap->irqs[i];
> > +
> > + cpcap_irq->reg_offset =
> > + ((i - irq_start) / cpcap->regmap_conf->val_bits) *
> > + cpcap->regmap_conf->reg_stride;
> > + cpcap_irq->mask = BIT(i % cpcap->regmap_conf->val_bits);
>
> If a code segment takes more than a few seconds to work out, it's
> either too cluttered (break it down), too complex (simplify it) or if
> neither of the first two approaches are possible, then a comment is
> required.
Hmm yeah I could not read that myself any longer :) Will split.
> > +static int cpcap_probe(struct spi_device *spi)
> > +{
> > + const struct of_device_id *match;
> > + int ret = -EINVAL;
>
> What is the purpose of initialising ret?
Seems to be not needed.
> > + struct cpcap_ddata *cpcap;
> > +
> > + match = of_match_device(of_match_ptr(cpcap_of_match), &spi->dev);
> > + if (!match)
> > + return -ENODEV;
> > +
> > + cpcap = devm_kzalloc(&spi->dev, sizeof(*cpcap), GFP_KERNEL);
> > + if (!cpcap)
> > + return -ENOMEM;
> > +
> > + cpcap->spi = spi;
> > + spi_set_drvdata(spi, cpcap);
> > +
> > + spi->bits_per_word = 16;
> > + spi->mode = SPI_MODE_0 | SPI_CS_HIGH;
> > +
> > + ret = spi_setup(spi);
> > + if (ret < 0)
> > + return ret;
>
> Is it possible for spi_setup() to return >0?
>
> If not, then "if (!ret)" will do.
You're right, the kerneldoc for spi_setup() says:
"Return: zero on success, else a negative error code."
Need to use "if (ret)" to return on error though, not "if (!ret)".
> > +static struct spi_driver cpcap_driver = {
> > + .driver = {
> > + .name = "cpcap-core",
> > + .of_match_table = cpcap_of_match,
>
> of_match_ptr() ?
Well there needs to be a platform specific init added at least in some
cases. I have not quite yet deciphered what all it does for droid 4
as it's already done for kexec based booting.
> > + * Copyright (C) 2016 Tony Lindgren <tony@xxxxxxxxxxx>.
>
> Actually, it's more traditional to place the CR at the top.
Sure. Will repost v4 shortly.
Thanks,
Tony
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
