On Mon, Jan 02, 2017 at 02:12:28PM -0800, Tony Lindgren wrote:
> * Tony Lindgren <tony@xxxxxxxxxxx> [161230 10:38]:
> > +static struct pinctrl_ops ti_iodelay_pinctrl_ops = {
> > + .get_groups_count = pinctrl_generic_get_group_count,
> > + .get_group_name = pinctrl_generic_get_group_name,
> > + .get_group_pins = pinctrl_generic_get_group_pins,
> > + .pin_dbg_show = ti_iodelay_pin_dbg_show,
> > + .dt_node_to_map = ti_iodelay_dt_node_to_map,
> > +};
> > +
> > +static struct pinconf_ops ti_iodelay_pinctrl_pinconf_ops = {
> > + .pin_config_group_get = ti_iodelay_pinconf_group_get,
> > + .pin_config_group_set = ti_iodelay_pinconf_group_set,
> > +#ifdef CONFIG_DEBUG_FS
> > + .pin_config_group_dbg_show = ti_iodelay_pinconf_group_dbg_show,
> > +#endif
>
> I noticed that .pin_dbg_show above needs ifdef CONFIG_DEBUGFS.
> Updated patch below.
>
> Regards,
>
> Tony
>
> 8< --------------------
> From tony Mon Sep 17 00:00:00 2001
> From: Nishanth Menon <nm@xxxxxx>
> Date: Tue, 27 Dec 2016 08:03:43 -0800
> Subject: [PATCH] pinctrl: Introduce TI IOdelay configuration driver
>
> SoC family such as DRA7 family of processors have, in addition
> to the regular muxing of pins (as done by pinctrl-single), a separate
> hardware module called IODelay which is also expected to be configured.
> The "IODelay" module has it's own register space that is independent
> of the control module and the padconf register area.
>
> With recent changes to the pinctrl framework, we can now support
> this hardware with a reasonably minimal driver by using #pinctrl-cells,
> GENERIC_PINCTRL_GROUPS and GENERIC_PINMUX_FUNCTIONS.
>
> It is advocated strongly in TI's official documentation considering
> the existing design of the DRA7 family of processors during mux or
> IODelay reconfiguration, there is a potential for a significant glitch
> which may cause functional impairment to certain hardware. It is
> hence recommended to do as little of muxing as absolutely necessary
> without I/O isolation (which can only be done in initial stages of
> bootloader).
>
> NOTE: with the system wide I/O isolation scheme present in DRA7 SoC
> family, it is not reasonable to do stop all I/O operations for every
> such pad configuration scheme. So, we will let it glitch when used in
> this mode.
>
> Even with the above limitation, certain functionality such as MMC has
> mandatory need for IODelay reconfiguration requirements, depending on
> speed of transfer. In these cases, with careful examination of usecase
> involved, the expected glitch can be controlled such that it does not
> impact functionality.
>
> In short, IODelay module support as a padconf driver being introduced
> here is not expected to do SoC wide I/O Isolation and is meant for
> a limited subset of IODelay configuration requirements that need to
> be dynamic and whose glitchy behavior will not cause functionality
> failure for that interface.
>
> IMPORTANT NOTE: we take the approach of keeping LOCK_BITs cleared
> to 0x0 at all times, even when configuring Manual IO Timing Modes.
> This is done by eliminating the LOCK_BIT=1 setting from Step
> of the Manual IO timing Mode configuration procedure. This option
> leaves the CFG_* registers unprotected from unintended writes to the
> CTRL_CORE_PAD_* registers while Manual IO Timing Modes are configured.
>
> This approach is taken to allow for a generic driver to exist in kernel
> world that has to be used carefully in required usecases.
>
> Signed-off-by: Nishanth Menon <nm@xxxxxx>
> Signed-off-by: Lokesh Vutla <lokeshvutla@xxxxxx>
> [tony@xxxxxxxxxxx: updated to use generic pinctrl functions, added
> binding documentation, updated comments]
> Signed-off-by: Tony Lindgren <tony@xxxxxxxxxxx>
> ---
> .../devicetree/bindings/pinctrl/ti,iodelay.txt | 47 +
Acked-by: Rob Herring <robh@xxxxxxxxxx>
> drivers/pinctrl/Kconfig | 1 +
> drivers/pinctrl/Makefile | 1 +
> drivers/pinctrl/ti/Kconfig | 10 +
> drivers/pinctrl/ti/Makefile | 1 +
> drivers/pinctrl/ti/pinctrl-ti-iodelay.c | 947 +++++++++++++++++++++
> 6 files changed, 1007 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/pinctrl/ti,iodelay.txt
> create mode 100644 drivers/pinctrl/ti/Kconfig
> create mode 100644 drivers/pinctrl/ti/Makefile
> create mode 100644 drivers/pinctrl/ti/pinctrl-ti-iodelay.c
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
