On Wednesday 19 October 2016 11:25:06 Pavel Machek wrote: > Hi! > > [Ccing lists.] > > > Can you push the patch, which gets further than negotiation into > > some git branch available to me? I tried to apply your patch to > > my code, but it did not work for me. > > Ok, I've pushed the branch to kernel.org: > > git push > git@xxxxxxxxxxxxxxxxxxx:pub/scm/linux/kernel/git/pavel/linux-n900.gi > t bt-2-v4.9:bt-2-v4.9 > > In retrospect, I did make some changes to dts, they may be > neccessary, too. > > If it still does not work, please try with my .config. I'm using > modules here, using this script: > > pavel@n900:/my/modules$ cat run2 > echo removing... > sudo killall a.out > rmmod nokia_h4p > #rmmod omap_serial > #rmmod serial_core > rmmod hci_uart.ko > #rmmod bcm2048.ko > echo installing... > insmod serial_core.ko > insmod omap-serial.ko > insmod bcm2048.ko > insmod hci_uart.ko > ls -al /dev/ttyO1 > sleep 1 > stty crtscts < /dev/ttyO1 > /my/tui/ofone/a.out & > > For the record, dmesg says: > > Good luck, > Pavel > > [ 30.694274] g_ether gadget: notify connect true > [ 30.714080] g_ether gadget: notify speed 425984000 > [ 127.719146] ssi-protocol ssi-protocol: WAKELINES TEST OK > [ 218.542694] of_get_named_gpiod_flags: can't parse 'rts-gpio' > property of node '/ocp@68000000/serial@4806c000[0]' > [ 218.546264] 4806c000.serial: ttyO1 at MMIO 0x4806c000 (irq = 89, > base_baud = 3000000) is a OMAP UART1 > [ 218.574157] of_get_named_gpiod_flags: can't parse 'rts-gpio' > property of node '/ocp@68000000/serial@49020000[0]' > [ 218.574340] 49020000.serial: ttyO2 at MMIO 0x49020000 (irq = 90, > base_baud = 3000000) is a OMAP UART2 > [ 218.650115] bcm2048: probe > [ 218.650177] bcm2048 4806c000.serial:bluetooth: GPIO lookup for > consumer reset > [ 218.650177] bcm2048 4806c000.serial:bluetooth: using device tree > for GPIO lookup > [ 218.650360] of_get_named_gpiod_flags: parsed 'reset-gpios' > property of node '/ocp@68000000/serial@4806c000/bluetooth[0]' - > status (0) [ 218.650390] bcm2048 4806c000.serial:bluetooth: GPIO > lookup for consumer host-wakeup > [ 218.650421] bcm2048 4806c000.serial:bluetooth: using device tree > for GPIO lookup > [ 218.650482] of_get_named_gpiod_flags: parsed 'host-wakeup-gpios' > property of node '/ocp@68000000/serial@4806c000/bluetooth[0]' - > status (0) > [ 218.650512] bcm2048 4806c000.serial:bluetooth: GPIO lookup for > consumer bluetooth-wakeup > [ 218.650543] bcm2048 4806c000.serial:bluetooth: using device tree > for GPIO lookup > [ 218.650604] of_get_named_gpiod_flags: parsed > 'bluetooth-wakeup-gpios' property of node > '/ocp@68000000/serial@4806c000/bluetooth[0]' - status (0) > [ 218.650817] bcm2048 4806c000.serial:bluetooth: parent uart: ttyO1 > [ 218.650817] bcm2048 4806c000.serial:bluetooth: sysclk speed: 38400 > kHz > [ 218.650848] bcm2048 4806c000.serial:bluetooth: probe: 0 > [ 218.774139] Bluetooth: HCI UART driver ver 2.3 > [ 218.774169] Bluetooth: HCI UART protocol H4 registered > [ 218.774169] Bluetooth: HCI UART protocol H4+ registered > [ 218.774169] Bluetooth: HCI UART protocol BCSP registered > [ 218.774200] Bluetooth: HCI UART protocol LL registered > [ 218.774200] Bluetooth: HCI UART protocol ATH3K registered > [ 218.774200] Bluetooth: HCI UART protocol Three-wire (H5) > registered [ 219.904876] tty ttyO1: Nokia H4+ protocol initialized > with 4806c000.serial:bluetooth! > [ 219.921112] tty ttyO1: Nokia H4+ protocol setup... > [ 219.921142] h4p_reset: reset > [ 219.921142] hci_uart_init_tty > [ 219.983520] h4p_reset: flush > [ 219.983551] h4p_reset: speed > [ 219.983581] tty ttyO1: setting speed to 120000 baud > [ 219.983673] h4p_reset: safety > [ 219.986480] tty ttyO1: wakeup received: 0 -> 1 > [ 220.013488] tty ttyO1: wait for cts... received! > [ 220.013519] h4p_reset: flow > [ 220.013549] tty ttyO1: Sending negotiation... > [ 220.013580] tty ttyO1: gpio state: reset=1 wakehost=1 wakebt=1 > [ 220.013610] enqueue: hu c304cc80 skb cd4da000 > [ 220.017425] tty ttyO1: H4P negotiation: > [ 220.017456] tty ttyO1: baudrate = 416 > [ 220.017486] tty ttyO1: system clock = 38400 > [ 220.017486] tty ttyO1: manufacturer id = 4 > [ 220.017486] tty ttyO1: version id = 11 > [ 220.017578] tty ttyO1: setting speed to 921600 baud > [ 220.043457] tty ttyO1: wait for cts... received! > [ 220.043548] tty ttyO1: Negotiation successful... > [ 220.043579] tty ttyO1: Sending alive packet... > [ 220.043579] enqueue: hu c304cc80 skb cd4dacc0 > [ 220.043853] tty ttyO1: Received alive packet! > [ 220.047851] tty ttyO1: FW: Skip negotion packet! > [ 220.047882] tty ttyO1: FW: Skip alive packet! > [ 220.052185] enqueue: hu c304cc80 skb cd4da480 > [ 220.055175] enqueue: hu c304cc80 skb cd4dae40 > [ 220.058776] enqueue: hu c304cc80 skb cd4da6c0 > [ 220.058898] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.058929] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.064605] enqueue: hu c304cc80 skb cd4daf00 > [ 220.068389] enqueue: hu c304cc80 skb cd4da0c0 > [ 220.068542] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.068542] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.071960] enqueue: hu c304cc80 skb cd4da840 > [ 220.072082] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.072082] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.075592] enqueue: hu c304cc80 skb cd4da180 > [ 220.079803] enqueue: hu c304cc80 skb cd479cc0 > [ 220.084381] enqueue: hu c304cc80 skb cd479180 > [ 220.087982] enqueue: hu c304cc80 skb cd4793c0 > [ 220.088104] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.088134] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.091522] enqueue: hu c304cc80 skb cd479e40 > [ 220.095336] enqueue: hu c304cc80 skb cd479540 > [ 220.098876] enqueue: hu c304cc80 skb cd479000 > [ 220.102386] enqueue: hu c304cc80 skb cd479600 > [ 220.102478] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.102508] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.105987] enqueue: hu c304cc80 skb cd479780 > [ 220.109527] enqueue: hu c304cc80 skb cd450cc0 > [ 220.109619] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.109649] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.113098] enqueue: hu c304cc80 skb cd484600 > [ 220.113220] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.113250] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.116760] enqueue: hu c304cc80 skb cd4a9b40 > [ 220.120300] enqueue: hu c304cc80 skb cd77c840 > [ 220.124786] enqueue: hu c304cc80 skb cd4f7900 > [ 220.128387] enqueue: hu c304cc80 skb c4fb2180 > [ 220.131896] enqueue: hu c304cc80 skb c4fb23c0 > [ 220.135498] enqueue: hu c304cc80 skb c4fb2cc0 > [ 220.139007] enqueue: hu c304cc80 skb c4fb2000 > [ 220.142486] enqueue: hu c304cc80 skb cd44fcc0 > [ 220.146118] enqueue: hu c304cc80 skb cd4b60c0 > [ 220.149627] enqueue: hu c304cc80 skb cf1986c0 > [ 220.153106] enqueue: hu c304cc80 skb cf198480 > [ 220.156738] enqueue: hu c304cc80 skb cf1980c0 > [ 220.160278] enqueue: hu c304cc80 skb cf198240 > [ 220.164733] enqueue: hu c304cc80 skb cd49f780 > [ 220.168365] enqueue: hu c304cc80 skb cd4daf00 > [ 220.171844] enqueue: hu c304cc80 skb cd4da6c0 > [ 220.175445] enqueue: hu c304cc80 skb cd4dab40 > [ 220.175567] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.175567] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.178955] enqueue: hu c304cc80 skb cd479780 > [ 220.182434] enqueue: hu c304cc80 skb cd479540 > [ 220.182525] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.182556] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.186035] enqueue: hu c304cc80 skb cd4793c0 > [ 220.188140] enqueue: hu c304cc80 skb cd479b40 > [ 220.188537] enqueue: hu c304cc80 skb cd484600 > [ 220.236480] enqueue: hu c304cc80 skb cd4a9f00 > [ 220.237701] enqueue: hu c304cc80 skb cd4f7900 > [ 220.238830] enqueue: hu c304cc80 skb c4fb23c0 > [ 220.239959] enqueue: hu c304cc80 skb c4fb2b40 > [ 220.241119] enqueue: hu c304cc80 skb c3107000 > [ 220.242187] enqueue: hu c304cc80 skb cd724240 > [ 220.243286] enqueue: hu c304cc80 skb cf198540 > [ 220.244781] enqueue: hu c304cc80 skb cf198540 > [ 220.245758] enqueue: hu c304cc80 skb cd49f780 > [ 220.246612] enqueue: hu c304cc80 skb cd4daf00 > [ 220.247436] enqueue: hu c304cc80 skb cd479540 > [ 220.248535] tty ttyO1: Sending radio packet... > [ 220.248565] enqueue: hu c304cc80 skb cd479cc0 > [ 220.248596] tty ttyO1: Radio packet sent > [ 220.249328] Bluetooth: hci0: Frame reassembly failed (-84) > [ 220.272949] tty ttyO1: wakeup received: 1 -> 0 > [ 221.283477] tty ttyO1: radio packet timeout! > [ 221.283630] enqueue: hu c304cc80 skb cd4a9b40 > [ 223.363372] Bluetooth: hci0 command 0xfc18 tx timeout > pavel@n900:~$ In log are still some failures, but ... is bluetooth working now? I see that you applied this patch: https://git.kernel.org/cgit/linux/kernel/git/pavel/linux-n900.git/commit/?id=051aa3fbf03ac770d8344690f5a936a7f04c6884 Looks like that pinmux is in DTS file incorrect. Can somebody verify it? Maybe Tony? -- Pali Rohár pali.rohar@xxxxxxxxx
Attachment:
signature.asc
Description: This is a digitally signed message part.