The ID pin GPIO comes from the PMIC. Let's configure it as a GPIO for the driver to use, and also make sure the PMIC GPIO pin muxing is correct. The PMIC pad1 and 2 values for omap5-uevm and igepv5 are 0x5a and 0x1b, we only need to clear bit 2 in pad1 register to make the ID pin GPIO work. Signed-off-by: Tony Lindgren <tony@xxxxxxxxxxx> --- arch/arm/boot/dts/omap5-board-common.dtsi | 9 +++++++++ arch/arm/boot/dts/omap5.dtsi | 2 +- 2 files changed, 10 insertions(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/omap5-board-common.dtsi b/arch/arm/boot/dts/omap5-board-common.dtsi index 6c5b0f8..10a466b 100644 --- a/arch/arm/boot/dts/omap5-board-common.dtsi +++ b/arch/arm/boot/dts/omap5-board-common.dtsi @@ -393,14 +393,23 @@ interrupt-controller; #interrupt-cells = <2>; ti,system-power-controller; + ti,mux-pad1 = <0xa1>; + ti,mux-pad2 = <0x1b>; pinctrl-names = "default"; pinctrl-0 = <&palmas_sys_nirq_pins &palmas_msecure_pins>; + palmas_gpio: gpio { + compatible = "ti,palmas-gpio"; + gpio-controller; + #gpio-cells = <2>; + }; + extcon_usb3: palmas_usb { compatible = "ti,palmas-usb-vid"; ti,enable-vbus-detection; ti,enable-id-detection; ti,wakeup; + id-gpios = <&palmas_gpio 0 GPIO_ACTIVE_HIGH>; }; clk32kgaudio: palmas_clk32k@1 { diff --git a/arch/arm/boot/dts/omap5.dtsi b/arch/arm/boot/dts/omap5.dtsi --- a/arch/arm/boot/dts/omap5.dtsi +++ b/arch/arm/boot/dts/omap5.dtsi @@ -863,7 +863,7 @@ #size-cells = <1>; utmi-mode = <2>; ranges; - dwc3@4a030000 { + dwc3: dwc3@4a030000 { compatible = "snps,dwc3"; reg = <0x4a030000 0x10000>; interrupts = <GIC_SPI 92 IRQ_TYPE_LEVEL_HIGH>, -- 2.9.3 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html