Le 01/04/2016 14:54, Boris Brezillon a écrit :
> The core now takes care of parsing generic DT properties in
> nand_scan_ident() when nand_set_flash_node() has been called.
> Rely on this initialization instead of calling of_get_nand_xxx()
> manually.
>
> Signed-off-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxxxxxxx>
It seems okay:
Reviewed-by: Nicolas Ferre <nicolas.ferre@xxxxxxxxx>
Thanks Boris, bye,
> ---
> drivers/mtd/nand/atmel_nand.c | 133 +++++++++++++++++++++++-------------------
> 1 file changed, 73 insertions(+), 60 deletions(-)
>
> diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
> index 0b5da72..5e716f2 100644
> --- a/drivers/mtd/nand/atmel_nand.c
> +++ b/drivers/mtd/nand/atmel_nand.c
> @@ -36,7 +36,6 @@
> #include <linux/of.h>
> #include <linux/of_device.h>
> #include <linux/of_gpio.h>
> -#include <linux/of_mtd.h>
> #include <linux/mtd/mtd.h>
> #include <linux/mtd/nand.h>
> #include <linux/mtd/partitions.h>
> @@ -434,14 +433,13 @@ err_buf:
> static void atmel_read_buf(struct mtd_info *mtd, u8 *buf, int len)
> {
> struct nand_chip *chip = mtd_to_nand(mtd);
> - struct atmel_nand_host *host = nand_get_controller_data(chip);
>
> if (use_dma && len > mtd->oobsize)
> /* only use DMA for bigger than oob size: better performances */
> if (atmel_nand_dma_op(mtd, buf, len, 1) == 0)
> return;
>
> - if (host->board.bus_width_16)
> + if (chip->options & NAND_BUSWIDTH_16)
> atmel_read_buf16(mtd, buf, len);
> else
> atmel_read_buf8(mtd, buf, len);
> @@ -450,14 +448,13 @@ static void atmel_read_buf(struct mtd_info *mtd, u8 *buf, int len)
> static void atmel_write_buf(struct mtd_info *mtd, const u8 *buf, int len)
> {
> struct nand_chip *chip = mtd_to_nand(mtd);
> - struct atmel_nand_host *host = nand_get_controller_data(chip);
>
> if (use_dma && len > mtd->oobsize)
> /* only use DMA for bigger than oob size: better performances */
> if (atmel_nand_dma_op(mtd, (void *)buf, len, 0) == 0)
> return;
>
> - if (host->board.bus_width_16)
> + if (chip->options & NAND_BUSWIDTH_16)
> atmel_write_buf16(mtd, buf, len);
> else
> atmel_write_buf8(mtd, buf, len);
> @@ -1507,58 +1504,17 @@ static void atmel_nand_hwctl(struct mtd_info *mtd, int mode)
> ecc_writel(host->ecc, CR, ATMEL_ECC_RST);
> }
>
> -static int atmel_of_init_port(struct atmel_nand_host *host,
> - struct device_node *np)
> +static int atmel_of_init_ecc(struct atmel_nand_host *host,
> + struct device_node *np)
> {
> - u32 val;
> u32 offset[2];
> - int ecc_mode;
> - struct atmel_nand_data *board = &host->board;
> - enum of_gpio_flags flags = 0;
> -
> - host->caps = (struct atmel_nand_caps *)
> - of_device_get_match_data(host->dev);
> -
> - if (of_property_read_u32(np, "atmel,nand-addr-offset", &val) == 0) {
> - if (val >= 32) {
> - dev_err(host->dev, "invalid addr-offset %u\n", val);
> - return -EINVAL;
> - }
> - board->ale = val;
> - }
> -
> - if (of_property_read_u32(np, "atmel,nand-cmd-offset", &val) == 0) {
> - if (val >= 32) {
> - dev_err(host->dev, "invalid cmd-offset %u\n", val);
> - return -EINVAL;
> - }
> - board->cle = val;
> - }
> -
> - ecc_mode = of_get_nand_ecc_mode(np);
> -
> - board->ecc_mode = ecc_mode < 0 ? NAND_ECC_SOFT : ecc_mode;
> -
> - board->on_flash_bbt = of_get_nand_on_flash_bbt(np);
> -
> - board->has_dma = of_property_read_bool(np, "atmel,nand-has-dma");
> -
> - if (of_get_nand_bus_width(np) == 16)
> - board->bus_width_16 = 1;
> -
> - board->rdy_pin = of_get_gpio_flags(np, 0, &flags);
> - board->rdy_pin_active_low = (flags == OF_GPIO_ACTIVE_LOW);
> -
> - board->enable_pin = of_get_gpio(np, 1);
> - board->det_pin = of_get_gpio(np, 2);
> + u32 val;
>
> host->has_pmecc = of_property_read_bool(np, "atmel,has-pmecc");
>
> - /* load the nfc driver if there is */
> - of_platform_populate(np, NULL, NULL, host->dev);
> -
> - if (!(board->ecc_mode == NAND_ECC_HW) || !host->has_pmecc)
> - return 0; /* Not using PMECC */
> + /* Not using PMECC */
> + if (!(host->nand_chip.ecc.mode == NAND_ECC_HW) || !host->has_pmecc)
> + return 0;
>
> /* use PMECC, get correction capability, sector size and lookup
> * table offset.
> @@ -1599,16 +1555,64 @@ static int atmel_of_init_port(struct atmel_nand_host *host,
> /* Will build a lookup table and initialize the offset later */
> return 0;
> }
> +
> if (!offset[0] && !offset[1]) {
> dev_err(host->dev, "Invalid PMECC lookup table offset\n");
> return -EINVAL;
> }
> +
> host->pmecc_lookup_table_offset_512 = offset[0];
> host->pmecc_lookup_table_offset_1024 = offset[1];
>
> return 0;
> }
>
> +static int atmel_of_init_port(struct atmel_nand_host *host,
> + struct device_node *np)
> +{
> + u32 val;
> + struct atmel_nand_data *board = &host->board;
> + enum of_gpio_flags flags = 0;
> +
> + host->caps = (struct atmel_nand_caps *)
> + of_device_get_match_data(host->dev);
> +
> + if (of_property_read_u32(np, "atmel,nand-addr-offset", &val) == 0) {
> + if (val >= 32) {
> + dev_err(host->dev, "invalid addr-offset %u\n", val);
> + return -EINVAL;
> + }
> + board->ale = val;
> + }
> +
> + if (of_property_read_u32(np, "atmel,nand-cmd-offset", &val) == 0) {
> + if (val >= 32) {
> + dev_err(host->dev, "invalid cmd-offset %u\n", val);
> + return -EINVAL;
> + }
> + board->cle = val;
> + }
> +
> + board->has_dma = of_property_read_bool(np, "atmel,nand-has-dma");
> +
> + board->rdy_pin = of_get_gpio_flags(np, 0, &flags);
> + board->rdy_pin_active_low = (flags == OF_GPIO_ACTIVE_LOW);
> +
> + board->enable_pin = of_get_gpio(np, 1);
> + board->det_pin = of_get_gpio(np, 2);
> +
> + /* load the nfc driver if there is */
> + of_platform_populate(np, NULL, NULL, host->dev);
> +
> + /*
> + * Initialize ECC mode to NAND_ECC_SOFT so that we have a correct value
> + * even if the nand-ecc-mode property is not defined.
> + */
> + host->nand_chip.ecc.mode = NAND_ECC_SOFT;
> +
> + return 0;
> +}
> +
> static int atmel_hw_nand_init_params(struct platform_device *pdev,
> struct atmel_nand_host *host)
> {
> @@ -2150,6 +2154,11 @@ static int atmel_nand_probe(struct platform_device *pdev)
> } else {
> memcpy(&host->board, dev_get_platdata(&pdev->dev),
> sizeof(struct atmel_nand_data));
> + nand_chip->ecc.mode = host->board.ecc_mode;
> +
> + /* 16-bit bus width */
> + if (host->board.bus_width_16)
> + nand_chip->options |= NAND_BUSWIDTH_16;
> }
>
> /* link the private data structures */
> @@ -2191,11 +2200,8 @@ static int atmel_nand_probe(struct platform_device *pdev)
> nand_chip->cmd_ctrl = atmel_nand_cmd_ctrl;
> }
>
> - nand_chip->ecc.mode = host->board.ecc_mode;
> nand_chip->chip_delay = 40; /* 40us command delay time */
>
> - if (host->board.bus_width_16) /* 16-bit bus width */
> - nand_chip->options |= NAND_BUSWIDTH_16;
>
> nand_chip->read_buf = atmel_read_buf;
> nand_chip->write_buf = atmel_write_buf;
> @@ -2228,11 +2234,6 @@ static int atmel_nand_probe(struct platform_device *pdev)
> }
> }
>
> - if (host->board.on_flash_bbt || on_flash_bbt) {
> - dev_info(&pdev->dev, "Use On Flash BBT\n");
> - nand_chip->bbt_options |= NAND_BBT_USE_FLASH;
> - }
> -
> if (!host->board.has_dma)
> use_dma = 0;
>
> @@ -2259,6 +2260,18 @@ static int atmel_nand_probe(struct platform_device *pdev)
> goto err_scan_ident;
> }
>
> + if (host->board.on_flash_bbt || on_flash_bbt)
> + nand_chip->bbt_options |= NAND_BBT_USE_FLASH;
> +
> + if (nand_chip->bbt_options & NAND_BBT_USE_FLASH)
> + dev_info(&pdev->dev, "Use On Flash BBT\n");
> +
> + if (IS_ENABLED(CONFIG_OF) && pdev->dev.of_node) {
> + res = atmel_of_init_ecc(host, pdev->dev.of_node);
> + if (res)
> + goto err_hw_ecc;
> + }
> +
> if (nand_chip->ecc.mode == NAND_ECC_HW) {
> if (host->has_pmecc)
> res = atmel_pmecc_nand_init_params(pdev, host);
>
--
Nicolas Ferre
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
