On these boards NAND ready pin status is avilable over GPMC_WAIT0 pin. For NAND we don't use GPMC wait pin monitoring but get the NAND Ready/Busy# status using GPIOlib. GPMC driver provides the WAIT0 pin status over GPIOlib. Read speed increases from 13212 KiB/ to 15753 KiB/s and write speed was unchanged at 4404 KiB/s. Measured using mtd_speedtest.ko on omap3-beagle-c4. Signed-off-by: Roger Quadros <rogerq@xxxxxx> --- arch/arm/boot/dts/omap3-beagle.dts | 1 + 1 file changed, 1 insertion(+) diff --git a/arch/arm/boot/dts/omap3-beagle.dts b/arch/arm/boot/dts/omap3-beagle.dts index 4602866..a4deff0 100644 --- a/arch/arm/boot/dts/omap3-beagle.dts +++ b/arch/arm/boot/dts/omap3-beagle.dts @@ -390,6 +390,7 @@ interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */ <1 IRQ_TYPE_NONE>; /* termcount */ ti,nand-ecc-opt = "ham1"; + rb-gpios = <&gpmc 0 GPIO_ACTIVE_HIGH>; /* gpmc_wait0 */ nand-bus-width = <16>; #address-cells = <1>; #size-cells = <1>; -- 2.5.0 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
