* Tony Lindgren <tony@xxxxxxxxxxx> [151201 16:42]: > * Matthijs van Duin <matthijsvanduin@xxxxxxxxx> [151201 16:11]: > > On 2 December 2015 at 00:38, Tony Lindgren <tony@xxxxxxxxxxx> wrote: > > > Looks like GPIO softreset status bit on both dm8168 and dm8148 > > > is broken and only goes high initially. After writing to sysc > > > softreset bit, the resetdone bit never goes high again. > > > > The resetdone bit works fine, but it needs all clocks active to come > > up. You're neglecting to enable the debounce clock to the GPIO module: > > > > > # mw.l 0x4818155c 0x2 > > > > That should write 0x102 instead. > > It seems to work only once based on what I've seen :) If you try it > after it's powered it never works. Could be I'm doing something wrong > of course.. > > > You can disable the debounce clock after resetting the module if you > > don't need it, though I doubt there's any significant power savings > > there. (More likely it exists as a separate bit to allow it to stay > > enabled even if the module isn't, for wakeup on debounced inputs.) > > Hmm I tried setting HWMOD_CONTROL_OPT_CLKS_IN_RESET flag like we > have for many SoCs to enable also sysclk18_ck but no luck. I can > recheck that. You're right with 0x102 it works, need to debug further. Thanks, Tony -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
