On-board spi-flash chip is used as a main boot device.
Add spi-flash chip support (over QSPI bus).
Signed-off-by: Dmitry Lifshitz <lifshitz@xxxxxxxxxxxxxx>
Acked-by: Igor Grinberg <grinberg@xxxxxxxxxxxxxx>
---
arch/arm/boot/dts/am57xx-cl-som-am57x.dts | 41 +++++++++++++++++++++++++++++++
1 file changed, 41 insertions(+)
diff --git a/arch/arm/boot/dts/am57xx-cl-som-am57x.dts b/arch/arm/boot/dts/am57xx-cl-som-am57x.dts
index ed50a75..cf2328d 100644
--- a/arch/arm/boot/dts/am57xx-cl-som-am57x.dts
+++ b/arch/arm/boot/dts/am57xx-cl-som-am57x.dts
@@ -93,6 +93,17 @@
DRA7XX_CORE_IOPAD(0x3498, PIN_INPUT_PULLUP | MUX_MODE1) /* gpmc_a22.mmc2_dat7 */
>;
};
+
+ qspi1_pins: pinmux_qspi1_pins {
+ pinctrl-single,pins = <
+ DRA7XX_CORE_IOPAD(0x3474, PIN_INPUT | MUX_MODE1) /* gpmc_a13.qspi1_rtclk */
+ DRA7XX_CORE_IOPAD(0x3480, PIN_INPUT | MUX_MODE1) /* gpmc_a16.qspi1_d0 */
+ DRA7XX_CORE_IOPAD(0x3484, PIN_INPUT | MUX_MODE1) /* gpmc_a17.qspi1_d1 */
+ DRA7XX_CORE_IOPAD(0x3488, PIN_INPUT | MUX_MODE1) /* qpmc_a18.qspi1_sclk */
+ DRA7XX_CORE_IOPAD(0x34b8, PIN_INPUT_PULLUP | MUX_MODE1) /* gpmc_cs2.qspi1_cs0 */
+ DRA7XX_CORE_IOPAD(0x34bc, PIN_INPUT_PULLUP | MUX_MODE1) /* gpmc_cs3.qspi1_cs1 */
+ >;
+ };
};
&i2c1 {
@@ -331,3 +342,33 @@
cap-mmc-dual-data-rate;
};
+&qspi {
+ status = "okay";
+ pinctrl-names = "default";
+ pinctrl-0 = <&qspi1_pins>;
+
+ spi_flash: spi_flash@0 {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ compatible = "jedec,spi-nor";
+ reg = <0>; /* CS0 */
+ spi-max-frequency = <20000000>;
+ spi-tx-bus-width = <1>;
+ spi-rx-bus-width = <1>;
+
+ partition@0 {
+ label = "uboot";
+ reg = <0x0 0xc0000>;
+ };
+
+ partition@c0000 {
+ label = "uboot environment";
+ reg = <0xc0000 0x40000>;
+ };
+
+ partition@100000 {
+ label = "reserved";
+ reg = <0x100000 0x0>;
+ };
+ };
+};
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
