Use the pinmux IOPAD macros to define the register as an offset from
the padconf physical address instead of the offset from padconf base.
This makes the DTS easier to read since matches the addresses listed
in the Technical Reference Manual.
Signed-off-by: Javier Martinez Canillas <javier@xxxxxxxxxxxxxxx>
---
arch/arm/boot/dts/omap4-panda-es.dts | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/arch/arm/boot/dts/omap4-panda-es.dts b/arch/arm/boot/dts/omap4-panda-es.dts
index 2f1dabcc6adf..119f8e657edc 100644
--- a/arch/arm/boot/dts/omap4-panda-es.dts
+++ b/arch/arm/boot/dts/omap4-panda-es.dts
@@ -34,23 +34,23 @@
/* PandaboardES has external pullups on SCL & SDA */
&dss_hdmi_pins {
pinctrl-single,pins = <
- 0x5a (PIN_INPUT_PULLUP | MUX_MODE0) /* hdmi_cec.hdmi_cec */
- 0x5c (PIN_INPUT | MUX_MODE0) /* hdmi_scl.hdmi_scl */
- 0x5e (PIN_INPUT | MUX_MODE0) /* hdmi_sda.hdmi_sda */
+ OMAP4_IOPAD(0x09a, PIN_INPUT_PULLUP | MUX_MODE0) /* hdmi_cec.hdmi_cec */
+ OMAP4_IOPAD(0x09c, PIN_INPUT | MUX_MODE0) /* hdmi_scl.hdmi_scl */
+ OMAP4_IOPAD(0x09e, PIN_INPUT | MUX_MODE0) /* hdmi_sda.hdmi_sda */
>;
};
&omap4_pmx_core {
led_gpio_pins: gpio_led_pmx {
pinctrl-single,pins = <
- 0xb6 (PIN_OUTPUT | MUX_MODE3) /* gpio_110 */
+ OMAP4_IOPAD(0x0f6, PIN_OUTPUT | MUX_MODE3) /* gpio_110 */
>;
};
};
&led_wkgpio_pins {
pinctrl-single,pins = <
- 0x1c (PIN_OUTPUT | MUX_MODE3) /* gpio_wk8 */
+ OMAP4_IOPAD(0x05c, PIN_OUTPUT | MUX_MODE3) /* gpio_wk8 */
>;
};
--
2.4.3
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
