From: Dominic Curran <dcurran@xxxxxx> Subject: [OMAPZOOM][PATCH] OV3640: Make camera sensor goto standby. This patch ensures that the OV3640 goes/comes back from standby when the kernel requests the appropriate power state. This also seems to fix an issue where ECC errors are seen at STREAMON time. This could possibly be because the sensor is probably still streaming when the receiver is being setup. Putting the sensor into standby would stop it streaming until setup of reciever is complete. Signed-off-by: Dominic Curran <dcurran@xxxxxx> --- arch/arm/mach-omap2/board-3430sdp.c | 4 +++- arch/arm/mach-omap2/board-ldp.c | 4 +++- 2 files changed, 6 insertions(+), 2 deletions(-) Index: omapzoom04/arch/arm/mach-omap2/board-3430sdp.c =================================================================== --- omapzoom04.orig/arch/arm/mach-omap2/board-3430sdp.c +++ omapzoom04/arch/arm/mach-omap2/board-3430sdp.c @@ -908,7 +908,8 @@ static int ov3640_sensor_power_set(enum mdelay(10); enable_fpga_vio_1v8(1); udelay(100); - } + } else + omap_set_gpio_dataout(OV3640_STANDBY_GPIO, 0); break; case V4L2_POWER_OFF: printk(KERN_DEBUG "ov3640_sensor_power_set(OFF)\n"); @@ -932,6 +933,7 @@ static int ov3640_sensor_power_set(enum break; case V4L2_POWER_STANDBY: printk(KERN_DEBUG "ov3640_sensor_power_set(STANDBY)\n"); + omap_set_gpio_dataout(OV3640_STANDBY_GPIO, 1); break; } previous_power = power; Index: omapzoom04/arch/arm/mach-omap2/board-ldp.c =================================================================== --- omapzoom04.orig/arch/arm/mach-omap2/board-ldp.c +++ omapzoom04/arch/arm/mach-omap2/board-ldp.c @@ -742,7 +742,8 @@ static int ov3640_sensor_power_set(enum omap_set_gpio_dataout(OV3640_RESET_GPIO, 0); udelay(100); omap_set_gpio_dataout(OV3640_RESET_GPIO, 1); - } + } else + omap_set_gpio_dataout(OV3640_STANDBY_GPIO, 0); break; case V4L2_POWER_OFF: printk(KERN_DEBUG "ov3640_sensor_power_set(OFF)\n"); @@ -764,6 +765,7 @@ static int ov3640_sensor_power_set(enum break; case V4L2_POWER_STANDBY: printk(KERN_DEBUG "ov3640_sensor_power_set(STANDBY)\n"); + omap_set_gpio_dataout(OV3640_STANDBY_GPIO, 1); break; } previous_power = power; -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
