Dave, thanks for rebasing your branch 2015-07-15 23:28 GMT+02:00 Dave Gerlach <d-gerlach@xxxxxx>: >> I tried to merge that branch into current v4.2-rc2, but I made quite a mess out >> of it. I'll try probably try cherry-picking next or will just wait for an update > > Yes, there are some additional patches, wkup_m3_rproc is just part of the whole > collection. However I did rebase my pm branch on v4.2-rc2 today in preparation > of sending the next series so you can check that out here: > https://github.com/dgerlach/linux-pm/tree/pm-v4.2-rc2-amx3-suspend. > > The firmware you need can be found here: > https://git.ti.com/ti-cm3-pm-firmware/amx3-cm3/commits/next-upstream. The file '/sys/power/state' is still empty, it seems that suspend_set_ops are never installed. [ 1.617027] omap_hsmmc 48060000.mmc: unable to get vmmc regulator -517 [ 1.652116] remoteproc0: wkup_m3 is available [ 1.657149] remoteproc0: Note: remoteproc is still under development and considered experimental. [ 1.666647] remoteproc0: THE BINARY FORMAT IS NOT YET FINALIZED, and backward compatibility isn't yet guaranteed. [ 1.686648] usbcore: registered new interface driver snd-usb-audio [ 1.699828] Initializing XFRM netlink socket [ 1.707462] NET: Registered protocol family 10 [ 1.716910] sit: IPv6 over IPv4 tunneling driver [ 1.724229] NET: Registered protocol family 17 [ 1.729231] NET: Registered protocol family 15 [ 1.734582] Key type dns_resolver registered [ 1.739342] omap_voltage_late_init: Voltage driver support not added [ 1.747483] ThumbEE CPU extension supported. [ 1.752018] Registering SWP/SWPB emulation handler [ 1.757140] am33xx_pm_init !!!!!!! [ 1.760720] am33xx_pm_init 1 [ 1.763739] am33xx_pm_init 2 [ 1.766790] PM: am33xx_push_sram_idle: EMIF function copy failed ^^^^^^^ next line in am33xx_pm_init would have installed the callbacks [ 1.830732] tps65217 0-0024: TPS65217 ID 0xf version 1.1 [ 1.838295] at24 0-0050: 1024 byte 24c08 EEPROM, writable, 16 bytes/write [ 1.845933] omap_i2c 44e0b000.i2c: bus 0 rev0.11 at 100 kHz [ 1.855157] omap_i2c 4819c000.i2c: bus 2 rev0.11 at 400 kHz [ 1.862975] nand: device found, Manufacturer ID: 0x98, Chip ID: 0xda [ 1.870123] remoteproc0: powering up wkup_m3 [ 1.874734] remoteproc0: Booting fw image am335x-pm-firmware.elf, size 153943 [ 1.882387] nand: Toshiba NAND 256MiB 3,3V 8-bit [ 1.887269] nand: 256 MiB, SLC, erase size: 128 KiB, page size: 2048, OOB size: 64 [ 1.895290] nand: using OMAP_ECC_BCH8_CODE_HW ECC scheme [ 1.901368] remoteproc0: remote processor wkup_m3 is now up [ 1.901394] wkup_m3_ipc 44e11324.wkup_m3_ipc: CM3 Firmware Version = 0x191 [ 1.915177] 9 ofpart partitions found on MTD device omap2-nand.0 kind regards, Andi -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
