On Mon, May 18, 2015 at 11:29 AM, Tony Lindgren <tony@xxxxxxxxxxx> wrote: > * Robert Nelson <robertcnelson@xxxxxxxxx> [150518 09:15]: >> On Mon, May 18, 2015 at 10:21 AM, Tony Lindgren <tony@xxxxxxxxxxx> wrote: >> >> All the rev information is in the board's eeprom: >> >> hexdump -e '8/1 "%c"' /sys/bus/i2c/devices/0-0050/eeprom -s 12 -n 4 >> >> Rev A5B >> 0A5B >> >> Rev C >> 000C >> >> Just another default qwerk to add to Pantelis' bone_capemgr. ;) > > It seems we should not even instantiate some devices on BBB > until the EEPROM is parsed.. So maybe something like this: > > 1. The problem devices are initially set with status = "disabled" > in the dts > > 2. We set up drivers/*/bbb-eeprom.c that parses the board > revision at module_init time, and then flips the selected > devices to have status = "enabled" and populates the revision > info based on the eeprom and SoC revision passed in pdata. > Then those devices get their struct device created and > probed, but at a much later time. > > So rather than trying to init all that early, let's just > init them much later when we have the proper I2C driver > running? I see that working just fine. We (beagleboard.org) enforce the eeprom data, as all the official images require a proper baseboard eeprom. We just have to be very careful to limit the scope, otherwise we will end up with Pantelis' rejected capebus from the v3.2.x days... Regards, -- Robert Nelson https://rcn-ee.com/ -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
