Hi, > -----Original Message----- > From: stanley.miao [mailto:stanley.miao@xxxxxxxxxxxxx] <snip> > > +static struct i2c_board_info __initdata ldp_i2c_boardinfo_2[] = { > > +#if defined(CONFIG_VIDEO_OV3640) || defined(CONFIG_VIDEO_OV3640_MODULE) > > + { > > + I2C_BOARD_INFO("ov3640", OV3640_I2C_ADDR), > > + .platform_data = &ldp_ov3640_platform_data, > > + }, > > +#endif > > +}; > > > This new added i2c_board_info was not registered. > After I added this line, > > omap_register_i2c_bus(2, 400, ldp_i2c_boardinfo_2, > ARRAY_SIZE(ldp_i2c_boardinfo_2)); > > the sensor was found. but the test still failed. A lot of error came out > when I run my test program. > > <3>CSI2: ComplexIO Error IRQ 80 > CSI2: ComplexIO Error IRQ 80 > <3>CSI2: ComplexIO Error IRQ c2 > CSI2: ComplexIO Error IRQ c2 > <3>CSI2: ComplexIO Error IRQ c2 > CSI2: ComplexIO Error IRQ c2 > <3>CSI2: ComplexIO Error IRQ c6 > CSI2: ComplexIO Error IRQ c6 > <3>CSI2: ECC correction failed > CSI2: ECC correction failed > <3>CSI2: ComplexIO Error IRQ 6 > CSI2: ComplexIO Error IRQ 6 > <3>CSI2: ComplexIO Error IRQ 6 > CSI2: ComplexIO Error IRQ 6 > <3>CSI2: ComplexIO Error IRQ 6 > CSI2: ComplexIO Error IRQ 6 > <3>CSI2: ComplexIO Error IRQ 6 > CSI2: ComplexIO Error IRQ 6 > Oops, my mistake. Missed to add that struct there... Fixed now. About the CSI2 errors you're receiving... Which version of LDP are you using? Which Silicon revision has (ES2.1 or ES3.0)? Regards, Sergio > > Stanley. -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
