Hi, This series will fix the following error during boot (both DT and legacy boot): [ 0.307739] omap_hwmod: mcbsp2: _wait_target_ready failed: -16 [ 0.307769] omap_hwmod: mcbsp2: cannot be enabled for reset (3) The clock definitions/aliases for McBSP ports were not correct. In case of DT boot we still have the following warning printed from hwmod: [ 0.222900] omap_hwmod: mcbsp2_sidetone using broken dt data from mcbsp [ 0.225311] omap_hwmod: mcbsp3_sidetone using broken dt data from mcbsp These are there because mcbsp is using two hwmods in the DT and hwmod prints out a warning for these. In legacy mode we also have 2 hwmods for McBSP2/3. One for the McBSP itself and the other for the sidetone block attached to them. I'll try to look into this one next. Since this series fixes the _wait_target_ready issue, can this be sent for 4.0? Regards, Peter --- Peter Ujfalusi (2): clk: ti: clk-3xxx: Correct McBSP related DT clock definitions clk: ti: clk-3xxx-legacy: Correct McBSP related clock aliases drivers/clk/ti/clk-3xxx-legacy.c | 16 +++++++++------- drivers/clk/ti/clk-3xxx.c | 19 +++++++------------ 2 files changed, 16 insertions(+), 19 deletions(-) -- 2.3.0 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
