* Mark Rutland <mark.rutland@xxxxxxx> [150205 10:26]: > On Thu, Feb 05, 2015 at 06:01:06PM +0000, Felipe Balbi wrote: > > allowing values to boolean flags lets us setup > > defaults on DTSI which can get disabled later > > at board DTS if, for whatever reason, board can't > > use that default. > > > > One such example is DM81xx EVM where we can't use > > MUSB's multipoint feature even though SoC supports > > it. Something at the board level prevents us from > > using the feature. > > > > Instead of removing "multipoint;" from DTSI and > > adding it to all board DTS just so we can remove > > it from our quirky board seems like overkill when > > we could just add: > > > > multipoint = <0>; > > > > to that quirky board's DTS. > > > > Note that the description here is but one example > > and it's likely many others have faced something > > similar. > > > > While I appreciate that adding and removing properties in this way is > painful, I think that this must be dealt with at DTB compile-time rather > than kernel run-time. > > There are codebases other than Linux which parse DTs, and not all > drivers call of_property_read_bool to parse boolean properties, an awful > lot still just check of_find_property. Additionally, some bindings > _explicitly_ state boolean properties are empty and have no value, which > this extension would break. > > I think that this patch only adds to the inconsistency we currently > have, and given that, I would rather not have this extension to > of_property_read_bool. > > Arguably of_proeprty_read_bool should warn if it encounters a non-empty > property. How about a WARN_ON there as in that case the value will always be set to 1 in kernel even if specified as 0 in the .dts file? Regards, Tony -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
