* Marek Belisko <marek@xxxxxxxxxxxxx> [150122 12:42]: > From: NeilBrown <neil@xxxxxxxxxx> > > Signed-off-by: NeilBrown <neil@xxxxxxxxxx> > --- > arch/arm/boot/dts/omap3-gta04.dtsi | 4 ++++ > 1 file changed, 4 insertions(+) > > diff --git a/arch/arm/boot/dts/omap3-gta04.dtsi b/arch/arm/boot/dts/omap3-gta04.dtsi > index 228e79b..8d2b0a1 100644 > --- a/arch/arm/boot/dts/omap3-gta04.dtsi > +++ b/arch/arm/boot/dts/omap3-gta04.dtsi > @@ -357,6 +357,10 @@ > pinctrl-0 = <&uart3_pins>; > }; > > +&uart4 { > + status = "disabled"; > +}; > + This you probably want to avoid from PM point of view. Depending on bootloader state of uart4, Linux may or may not be able to hit any deeper power states. Marking something with status = "disabled" in dts causes the device entry not even to be created. That means hwmod won't be able to reset and idle this device during boot. The uart4 device is there for sure even if not muxed and in incomplete state. You may want to also check other places where you're using status = "disabled" for the same reasons. Regards, Tony -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html