On Fri, Sep 12, 2014 at 11:51:22AM +0200, Sebastian Andrzej Siewior wrote: > On 09/12/2014 11:40 AM, Frans Klaver wrote: > > > I'm not sure. I just reproduced this on a boneblack, using your uart_v9 > > branch. > > > >> This problem only pops-up if you use DMA. With disabled DMA you don't > >> see this, right? > > > > I get the lockup both with and without DMA enabled. Here's the 8250 > > config I use. Our full .config is attached in case it may provide > > something relevant. > > Hmm. I have a bone black here. Can you tell what you did to get this > lockup? The port configuration (unless 115200 8N1) and what you did to > get this lockup. port config is 115200 8N1. I don't recall doing anything special. I boot, login, less file and get a lock. > > Something that may also help: when I have a lockup on the boneblack, dma > > is enabled and something is written to console like I described earlier, > > I get the following bad irq: > > > Full dmesg is also attached. > > This one should be stuffed by this: > "[RFC] ARM: edma: unconditionally ack the error interrupt" > https://lkml.org/lkml/2014/9/10/714 OK, that makes the console usable again after I write something to kmsg. > > Hope you find something useful in there. > > > Thanks, > > Frans > > Sebastian -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html