The board has 2 CAN ports but only the first one can be used.
Enable the first CAN port.
The second one cannot be used without hardware modification
so we don't enable the second port.
Signed-off-by: Roger Quadros <rogerq@xxxxxx>
Reviewed-by: Felipe Balbi <balbi@xxxxxx>
---
arch/arm/boot/dts/dra7-evm.dts | 21 +++++++++++++++++++++
1 file changed, 21 insertions(+)
diff --git a/arch/arm/boot/dts/dra7-evm.dts b/arch/arm/boot/dts/dra7-evm.dts
index e03fbf3..d6b9b27 100644
--- a/arch/arm/boot/dts/dra7-evm.dts
+++ b/arch/arm/boot/dts/dra7-evm.dts
@@ -171,6 +171,20 @@
0xd0 (PIN_OUTPUT | MUX_MODE0) /* gpmc_be0n_cle */
>;
};
+
+ dcan1_pins_default: dcan1_pins_default {
+ pinctrl-single,pins = <
+ 0x3d4 (PIN_INPUT | MUX_MODE0) /* dcan1_tx */
+ 0x3d8 (PIN_INPUT | MUX_MODE0) /* dcan1_rx */
+ >;
+ };
+
+ dcan1_pins_sleep: dcan1_pins_sleep {
+ pinctrl-single,pins = <
+ 0x3d4 (PIN_INPUT | MUX_MODE15) /* dcan1_tx */
+ 0x3d8 (PIN_INPUT | MUX_MODE15) /* dcan1_rx */
+ >;
+ };
};
&i2c1 {
@@ -529,3 +543,10 @@
ti,no-reset-on-init;
ti,no-idle-on-init;
};
+
+&dcan1 {
+ status = "ok";
+ pinctrl-names = "default", "sleep";
+ pinctrl-0 = <&dcan1_pins_default>;
+ pinctrl-1 = <&dcan1_pins_sleep>;
+};
--
1.8.3.2
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
