On Wednesday 18 February 2009, greg@xxxxxxxxx wrote:
> From: Ajay Kumar Gupta <ajay.gupta@xxxxxx>
>
> Tested with Creative (Live! Cam Optia) USB camera which uses
> high bandwidth isochronous interface.FIFO table has been updated
> for Rx high bandwidth case.
>
> Signed-off-by: Ajay Kumar Gupta <ajay.gupta@xxxxxx>
> Cc: Felipe Balbi <felipe.balbi@xxxxxxxxx>
> Cc: David Brownell <dbrownell@xxxxxxxxxxxxxxxxxxxxx>
NAK on this one ... Ajay, please re-issue with udpates
to verify that the silicon supports high bandwith ISO!
There's code in musb_core_init():
if (reg & MUSB_CONFIGDATA_HBRXE) {
strcat(aInfo, ", HB-ISO Rx");
strcat(aInfo, " (X)"); /* no driver support */
}
if (reg & MUSB_CONFIGDATA_HBTXE) {
strcat(aInfo, ", HB-ISO Tx");
strcat(aInfo, " (X)"); /* no driver support */
}
What it needs to do is save a flag instead of
printing the " (X)" ... and test that flag later,
instead of assuming it's set.
Examples:
- DaVinci DM6446 and DM355 don't support high bandwidth
for either RX or TX.
- Neither does TUSB6010 (and presumably TUSB6020), which
was sort of extracted from the DM6446 (adding more RAM,
splitting out the fibula and tibula chips, etc)
- OMAP3 ES2.1 and ES3.1 support it for RX and TX ... but
the ES3.0 chips only support it for RX (goofage?)
I don't know what the Blackfin or ST-Micro parts do, but
one shouldn't assume they always support it either.
Also, I suspect you should probably create a new fifo_mode
table to support this. These changes will break some
composite gadget code I've seen ... and I'm curious why
you didn't just configure that endpoint in shared-FIFO mode,
so that it'd support both RX and TX in high bandwidth.
- Dave
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
