On 25 Jun 04:38 AM, Gupta, Pekon wrote: > >From: Ezequiel Garcia > >>On 24 Jun 05:54 PM, Pekon Gupta wrote: > >> This patch adds support for LCD4 cape as advertised on > >> http://elinux.org/CircuitCo:BeagleBone_LCD4 > >> > >> This cape has: > >> * 480x272 TFT-LCD panel > >> - LCD panel datasheet and timing information are sourced from [1] > >> - LCD backlight is connected to 'EHRPWM1A' on cape board, but its used for > >> enabling backlight power-supply. So 'gpio-backlight' driver is used instead > >> of 'pwm-backlight' driver (Kconfig: BACKLIGHT_GPIO=y). > >> > > > >I'm confused about this, can you clarify why you are not using pwm-backlight? > > > > As per the schematics of this LCD4 cape board, "EHRPWM1A" pin controls > enabling/disabling of the power to backlight LED. It does not control the > voltage levels (brightness levels) of the LED. Thus it wasn't making sense > to use pwm-backlight driver which more suitable in cases where you have > multiple levels of brightness. > Here, you have only 2 levels "backlight=off | on", so I used gpio-backlight driver. > Though you can use pwm-backlight driver also, but the backlight turns ON > only when you set the /sys/class/backlight/<backlight_device>/brighteness > to maximum level (as set in DT). > Hm, I didn't know that. Thanks for this information. -- Ezequiel Garcia, VanguardiaSur www.vanguardiasur.com.ar -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html