On 5/29/2014 12:23 AM, Greg KH wrote:
On Wed, May 28, 2014 at 02:27:13PM +0530, Satish Patel wrote:
SmartCard controller uses this interface to communicate with
SmartCard via PHY
Some SmartCard PHY has multiple slots for cards.
This inerface also enables controller to communicate
with one or more SmartCard connected over phy.
interface structure includes following APIs
- set/get config
- activate/deactivate smart card
- warm reset
- register_notify (for card insert/remove/overheat)
- unregister_notify
Signed-off-by: Satish Patel <satish.patel@xxxxxx>
---
Documentation/sc_phy.txt | 171 ++++++++++++++++++++++++++++++++++++++++++++++
include/linux/sc_phy.h | 136 ++++++++++++++++++++++++++++++++++++
2 files changed, 307 insertions(+)
create mode 100644 Documentation/sc_phy.txt
create mode 100644 include/linux/sc_phy.h
These are .h files, but where is the "api" functions that use
these structures defined at?
This is like template/wrappers, smart card phy driver will write API
functions. And smartcard controller will call these functions.
With proposed approach, smartcard controller can communicate with any
smart card phy (TI/NxP) without change in code. Using DT entry smartcard
and PHY will gets connected with each other.
Refer diagram given @Documentation/sc_phy.txt.
confused,
greg k-h
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
