Add device_timings, gpmc_timings and gpmc_setting to
gpmc platform data.
Signed-off-by: Roger Quadros <rogerq@xxxxxx>
---
arch/arm/mach-omap2/gpmc.h | 125 ------------------------------
include/linux/platform_data/gpmc-omap.h | 131 ++++++++++++++++++++++++++++++++
2 files changed, 131 insertions(+), 125 deletions(-)
diff --git a/arch/arm/mach-omap2/gpmc.h b/arch/arm/mach-omap2/gpmc.h
index c476712..681977f 100644
--- a/arch/arm/mach-omap2/gpmc.h
+++ b/arch/arm/mach-omap2/gpmc.h
@@ -79,131 +79,6 @@
#define GPMC_MUX_AAD 1 /* Addr-Addr-Data multiplex */
#define GPMC_MUX_AD 2 /* Addr-Data multiplex */
-/* bool type time settings */
-struct gpmc_bool_timings {
- bool cycle2cyclediffcsen;
- bool cycle2cyclesamecsen;
- bool we_extra_delay;
- bool oe_extra_delay;
- bool adv_extra_delay;
- bool cs_extra_delay;
- bool time_para_granularity;
-};
-
-/*
- * Note that all values in this struct are in nanoseconds except sync_clk
- * (which is in picoseconds), while the register values are in gpmc_fck cycles.
- */
-struct gpmc_timings {
- /* Minimum clock period for synchronous mode (in picoseconds) */
- u32 sync_clk;
-
- /* Chip-select signal timings corresponding to GPMC_CS_CONFIG2 */
- u32 cs_on; /* Assertion time */
- u32 cs_rd_off; /* Read deassertion time */
- u32 cs_wr_off; /* Write deassertion time */
-
- /* ADV signal timings corresponding to GPMC_CONFIG3 */
- u32 adv_on; /* Assertion time */
- u32 adv_rd_off; /* Read deassertion time */
- u32 adv_wr_off; /* Write deassertion time */
-
- /* WE signals timings corresponding to GPMC_CONFIG4 */
- u32 we_on; /* WE assertion time */
- u32 we_off; /* WE deassertion time */
-
- /* OE signals timings corresponding to GPMC_CONFIG4 */
- u32 oe_on; /* OE assertion time */
- u32 oe_off; /* OE deassertion time */
-
- /* Access time and cycle time timings corresponding to GPMC_CONFIG5 */
- u32 page_burst_access; /* Multiple access word delay */
- u32 access; /* Start-cycle to first data valid delay */
- u32 rd_cycle; /* Total read cycle time */
- u32 wr_cycle; /* Total write cycle time */
-
- u32 bus_turnaround;
- u32 cycle2cycle_delay;
-
- u32 wait_monitoring;
- u32 clk_activation;
-
- /* The following are only on OMAP3430 */
- u32 wr_access; /* WRACCESSTIME */
- u32 wr_data_mux_bus; /* WRDATAONADMUXBUS */
-
- struct gpmc_bool_timings bool_timings;
-};
-
-/* Device timings in picoseconds */
-struct gpmc_device_timings {
- u32 t_ceasu; /* address setup to CS valid */
- u32 t_avdasu; /* address setup to ADV valid */
- /* XXX: try to combine t_avdp_r & t_avdp_w. Issue is
- * of tusb using these timings even for sync whilst
- * ideally for adv_rd/(wr)_off it should have considered
- * t_avdh instead. This indirectly necessitates r/w
- * variations of t_avdp as it is possible to have one
- * sync & other async
- */
- u32 t_avdp_r; /* ADV low time (what about t_cer ?) */
- u32 t_avdp_w;
- u32 t_aavdh; /* address hold time */
- u32 t_oeasu; /* address setup to OE valid */
- u32 t_aa; /* access time from ADV assertion */
- u32 t_iaa; /* initial access time */
- u32 t_oe; /* access time from OE assertion */
- u32 t_ce; /* access time from CS asertion */
- u32 t_rd_cycle; /* read cycle time */
- u32 t_cez_r; /* read CS deassertion to high Z */
- u32 t_cez_w; /* write CS deassertion to high Z */
- u32 t_oez; /* OE deassertion to high Z */
- u32 t_weasu; /* address setup to WE valid */
- u32 t_wpl; /* write assertion time */
- u32 t_wph; /* write deassertion time */
- u32 t_wr_cycle; /* write cycle time */
-
- u32 clk;
- u32 t_bacc; /* burst access valid clock to output delay */
- u32 t_ces; /* CS setup time to clk */
- u32 t_avds; /* ADV setup time to clk */
- u32 t_avdh; /* ADV hold time from clk */
- u32 t_ach; /* address hold time from clk */
- u32 t_rdyo; /* clk to ready valid */
-
- u32 t_ce_rdyz; /* XXX: description ?, or use t_cez instead */
- u32 t_ce_avd; /* CS on to ADV on delay */
-
- /* XXX: check the possibility of combining
- * cyc_aavhd_oe & cyc_aavdh_we
- */
- u8 cyc_aavdh_oe;/* read address hold time in cycles */
- u8 cyc_aavdh_we;/* write address hold time in cycles */
- u8 cyc_oe; /* access time from OE assertion in cycles */
- u8 cyc_wpl; /* write deassertion time in cycles */
- u32 cyc_iaa; /* initial access time in cycles */
-
- /* extra delays */
- bool ce_xdelay;
- bool avd_xdelay;
- bool oe_xdelay;
- bool we_xdelay;
-};
-
-struct gpmc_settings {
- bool burst_wrap; /* enables wrap bursting */
- bool burst_read; /* enables read page/burst mode */
- bool burst_write; /* enables write page/burst mode */
- bool device_nand; /* device is NAND */
- bool sync_read; /* enables synchronous reads */
- bool sync_write; /* enables synchronous writes */
- bool wait_on_read; /* monitor wait on reads */
- bool wait_on_write; /* monitor wait on writes */
- u32 burst_len; /* page/burst length */
- u32 device_width; /* device bus width (8 or 16 bit) */
- u32 mux_add_data; /* multiplex address & data */
- u32 wait_pin; /* wait-pin to be used */
-};
extern int gpmc_calc_timings(struct gpmc_timings *gpmc_t,
struct gpmc_settings *gpmc_s,
diff --git a/include/linux/platform_data/gpmc-omap.h b/include/linux/platform_data/gpmc-omap.h
index bff352f..52b6504 100644
--- a/include/linux/platform_data/gpmc-omap.h
+++ b/include/linux/platform_data/gpmc-omap.h
@@ -22,10 +22,141 @@ enum gpmc_omap_type {
GPMC_OMAP_TYPE_GENERIC,
};
+/* bool type time settings */
+struct gpmc_bool_timings {
+ bool cycle2cyclediffcsen;
+ bool cycle2cyclesamecsen;
+ bool we_extra_delay;
+ bool oe_extra_delay;
+ bool adv_extra_delay;
+ bool cs_extra_delay;
+ bool time_para_granularity;
+};
+
+/*
+ * Note that all values in this struct are in nanoseconds except sync_clk
+ * (which is in picoseconds), while the register values are in gpmc_fck cycles.
+ */
+struct gpmc_timings {
+ /* Minimum clock period for synchronous mode (in picoseconds) */
+ u32 sync_clk;
+
+ /* Chip-select signal timings corresponding to GPMC_CS_CONFIG2 */
+ u32 cs_on; /* Assertion time */
+ u32 cs_rd_off; /* Read deassertion time */
+ u32 cs_wr_off; /* Write deassertion time */
+
+ /* ADV signal timings corresponding to GPMC_CONFIG3 */
+ u32 adv_on; /* Assertion time */
+ u32 adv_rd_off; /* Read deassertion time */
+ u32 adv_wr_off; /* Write deassertion time */
+
+ /* WE signals timings corresponding to GPMC_CONFIG4 */
+ u32 we_on; /* WE assertion time */
+ u32 we_off; /* WE deassertion time */
+
+ /* OE signals timings corresponding to GPMC_CONFIG4 */
+ u32 oe_on; /* OE assertion time */
+ u32 oe_off; /* OE deassertion time */
+
+ /* Access time and cycle time timings corresponding to GPMC_CONFIG5 */
+ u32 page_burst_access; /* Multiple access word delay */
+ u32 access; /* Start-cycle to first data valid delay */
+ u32 rd_cycle; /* Total read cycle time */
+ u32 wr_cycle; /* Total write cycle time */
+
+ u32 bus_turnaround;
+ u32 cycle2cycle_delay;
+
+ u32 wait_monitoring;
+ u32 clk_activation;
+
+ /* The following are only on OMAP3430 */
+ u32 wr_access; /* WRACCESSTIME */
+ u32 wr_data_mux_bus; /* WRDATAONADMUXBUS */
+
+ struct gpmc_bool_timings bool_timings;
+};
+
+
+/* Device timings in picoseconds */
+struct gpmc_device_timings {
+ u32 t_ceasu; /* address setup to CS valid */
+ u32 t_avdasu; /* address setup to ADV valid */
+ /* XXX: try to combine t_avdp_r & t_avdp_w. Issue is
+ * of tusb using these timings even for sync whilst
+ * ideally for adv_rd/(wr)_off it should have considered
+ * t_avdh instead. This indirectly necessitates r/w
+ * variations of t_avdp as it is possible to have one
+ * sync & other async
+ */
+ u32 t_avdp_r; /* ADV low time (what about t_cer ?) */
+ u32 t_avdp_w;
+ u32 t_aavdh; /* address hold time */
+ u32 t_oeasu; /* address setup to OE valid */
+ u32 t_aa; /* access time from ADV assertion */
+ u32 t_iaa; /* initial access time */
+ u32 t_oe; /* access time from OE assertion */
+ u32 t_ce; /* access time from CS asertion */
+ u32 t_rd_cycle; /* read cycle time */
+ u32 t_cez_r; /* read CS deassertion to high Z */
+ u32 t_cez_w; /* write CS deassertion to high Z */
+ u32 t_oez; /* OE deassertion to high Z */
+ u32 t_weasu; /* address setup to WE valid */
+ u32 t_wpl; /* write assertion time */
+ u32 t_wph; /* write deassertion time */
+ u32 t_wr_cycle; /* write cycle time */
+
+ u32 clk;
+ u32 t_bacc; /* burst access valid clock to output delay */
+ u32 t_ces; /* CS setup time to clk */
+ u32 t_avds; /* ADV setup time to clk */
+ u32 t_avdh; /* ADV hold time from clk */
+ u32 t_ach; /* address hold time from clk */
+ u32 t_rdyo; /* clk to ready valid */
+
+ u32 t_ce_rdyz; /* XXX: description ?, or use t_cez instead */
+ u32 t_ce_avd; /* CS on to ADV on delay */
+
+ /* XXX: check the possibility of combining
+ * cyc_aavhd_oe & cyc_aavdh_we
+ */
+ u8 cyc_aavdh_oe;/* read address hold time in cycles */
+ u8 cyc_aavdh_we;/* write address hold time in cycles */
+ u8 cyc_oe; /* access time from OE assertion in cycles */
+ u8 cyc_wpl; /* write deassertion time in cycles */
+ u32 cyc_iaa; /* initial access time in cycles */
+
+ /* extra delays */
+ bool ce_xdelay;
+ bool avd_xdelay;
+ bool oe_xdelay;
+ bool we_xdelay;
+};
+
+struct gpmc_settings {
+ bool burst_wrap; /* enables wrap bursting */
+ bool burst_read; /* enables read page/burst mode */
+ bool burst_write; /* enables write page/burst mode */
+ bool device_nand; /* device is NAND */
+ bool sync_read; /* enables synchronous reads */
+ bool sync_write; /* enables synchronous writes */
+ bool wait_on_read; /* monitor wait on reads */
+ bool wait_on_write; /* monitor wait on writes */
+ u32 burst_len; /* page/burst length */
+ u32 device_width; /* device bus width (8 or 16 bit) */
+ u32 mux_add_data; /* multiplex address & data */
+ u32 wait_pin; /* wait-pin to be used */
+};
+
+
/* Data for each chip select */
struct gpmc_omap_cs_data {
bool valid; /* data is valid */
enum gpmc_omap_type type;
+ struct gpmc_settings *settings;
+ struct gpmc_device_timings *device_timings;
+ struct gpmc_timings *gpmc_timings;
struct platform_device *pdev; /* device within this CS region */
unsigned pdata_size;
};
--
1.8.3.2
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
