Re: [PATCH] arm/dts: am335x-evmsk enable display and lcd panel support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 06/05/14 19:10, Tony Lindgren wrote:
> * Darren Etheridge <detheridge@xxxxxx> [140422 13:39]:
>> Add the necessary nodes to enable the LCD controller and the
>> LCD panel that is attached to the Texas Instruments AM335x
>> EVMSK platform.  Also setup the necessary pin mux within the
>> DT file to drive the LCD connector and add the correct
>> pinmux settings for the lcd pins to be configured to when
>> the SoC goes into sleep state for the minimum power
>> consumption.
>>
>> For the sleep mode LCD pin settings, MUX_MODE7 is chosen as
>> this corresponds to switching the pins into input GPIO's with
>> an internal pulldown.  Which has been determined to offer the
>> lowest power solution vs leaving the pins configured in LCD
>> mode.
> 
> Probably best that Tomi queues all the panel .dts changes into
> a separate immutable branch that I can merge too.

This is not for OMAP DSS, but for the LCDC used in beaglebone, so there
are no dependencies to any of my work.

 Tomi


Attachment: signature.asc
Description: OpenPGP digital signature


[Index of Archives]     [Linux Arm (vger)]     [ARM Kernel]     [ARM MSM]     [Linux Tegra]     [Linux WPAN Networking]     [Linux Wireless Networking]     [Maemo Users]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite Trails]     [Linux Kernel]     [Linux SCSI]

  Powered by Linux