Hello Koen, On Fri, May 2, 2014 at 12:47 PM, Koen Kooi <koen@xxxxxxxxxxxxxxxxxxxxx> wrote: > Hi, > > I've been trying to get DVI on my beagleboard XM to output a picture with mainline and with 3.15rc it still doesn't work. If I statically build in everything the drm encoders and connectors all go into deferred probe mode and fail, falling back to 1024x768. I with omapdrm and encoders/outputs/etc as modules deferred probe is avoided, far fewer error messages and a 1280x1024 resolution is being used. But still the monitor still says 'no signal' detected. > > So what's the magic to get an actual signal on the hdmi connector? > > regards, > > Koen-- This is a known issue as far as I know. You need [0] to correctly set the display PLL clock rates. Best regards, Javier [0]: http://permalink.gmane.org/gmane.linux.ports.arm.kernel/295077 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
