The ARCH_OMAP config option was used to built the GPIO OMAP driver but this is not consistent with the rest of the GPIO drivers that have their own Kconfig option. Also, this make it harder to add dependencies or reverse dependencies (i.e: select) since that would mean touching the sub-arch config option. So is better to add a boolean Kconfig option for this driver that defaults to true if ARCH_OMAP is enabled. Signed-off-by: Javier Martinez Canillas <javier.martinez@xxxxxxxxxxxxxxx> --- drivers/gpio/Kconfig | 7 +++++++ drivers/gpio/Makefile | 2 +- 2 files changed, 8 insertions(+), 1 deletion(-) diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig index 92d8e9a..bfe5cf0 100644 --- a/drivers/gpio/Kconfig +++ b/drivers/gpio/Kconfig @@ -243,6 +243,13 @@ config GPIO_OCTEON Say yes here to support the on-chip GPIO lines on the OCTEON family of SOCs. +config GPIO_OMAP + bool "TI OMAP GPIO support" + default y if ARCH_OMAP + depends on ARM && ARCH_OMAP + help + Say yes here to enable GPIO support for TI OMAP SoCs. + config GPIO_PL061 bool "PrimeCell PL061 GPIO support" depends on ARM_AMBA diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile index 6309aff..d10f6a9 100644 --- a/drivers/gpio/Makefile +++ b/drivers/gpio/Makefile @@ -58,7 +58,7 @@ obj-$(CONFIG_GPIO_MVEBU) += gpio-mvebu.o obj-$(CONFIG_GPIO_MXC) += gpio-mxc.o obj-$(CONFIG_GPIO_MXS) += gpio-mxs.o obj-$(CONFIG_GPIO_OCTEON) += gpio-octeon.o -obj-$(CONFIG_ARCH_OMAP) += gpio-omap.o +obj-$(CONFIG_GPIO_OMAP) += gpio-omap.o obj-$(CONFIG_GPIO_PCA953X) += gpio-pca953x.o obj-$(CONFIG_GPIO_PCF857X) += gpio-pcf857x.o obj-$(CONFIG_GPIO_PCH) += gpio-pch.o -- 1.9.0 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
