Hi, On 02/19/2014 03:56 PM, Balaji T K wrote: > Few cleanups to reduce code indent, > Add pbias_regulator support and adapt omap_hsmmc to use pbias regulator > to configure required voltage on mmc1 pad(SD card) i/o rails on OMAP SoCs. > I tested on both OMAP3630 (Overo Storm) and OMAP4430 (DuoVero). The rootfs is mounted on mmc1 and works as usual. Here is what I can see: - pbias-supply is parsed from DT - VMMC1 is set to 3V - According to the debugfs entry, we are working at 3V signaling - By dumping CONTROL_PBIASLITE, bit MMC1_PBIASLITE_VMODE (PBIASLITEVMODE0 on OMAP3) is set to 1 (-> 3V) Do you see any other tests that I could run to validate your patches? Otherwise: Tested-by: Florian Vaussard <florian.vaussard@xxxxxxx> > Balaji T K (7): > mmc: omap_hsmmc: use devm_regulator API > mmc: omap_hsmmc: handle vcc and vcc_aux independently > regulator: add pbias regulator support > mmc: omap_hsmmc: adapt hsmmc to use pbias regulator > ARM: dts: add pbias dt node > ARM: OMAP: enable SYSCON and REGULATOR_PBIAS in omap2plus_defconfig > mmc: omap_hsmmc: remove pbias workaround > > .../bindings/regulator/pbias-regulator.txt | 27 ++ > arch/arm/boot/dts/dra7.dtsi | 17 ++ > arch/arm/boot/dts/omap2430.dtsi | 17 ++ > arch/arm/boot/dts/omap3.dtsi | 17 ++ > arch/arm/boot/dts/omap4.dtsi | 17 ++ > arch/arm/boot/dts/omap5.dtsi | 17 ++ > arch/arm/configs/omap2plus_defconfig | 2 + > drivers/mmc/host/omap_hsmmc.c | 111 +++++---- > drivers/regulator/Kconfig | 9 + > drivers/regulator/Makefile | 1 + > drivers/regulator/pbias-regulator.c | 255 ++++++++++++++++++++ > 11 files changed, 441 insertions(+), 49 deletions(-) > create mode 100644 Documentation/devicetree/bindings/regulator/pbias-regulator.txt > create mode 100644 drivers/regulator/pbias-regulator.c > -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
