Enable promiscuous mode support for CPSW.
Signed-off-by: Mugunthan V N <mugunthanvnm@xxxxxx>
---
drivers/net/ethernet/ti/cpsw.c | 101 ++++++++++++++++++++++++++++---------
drivers/net/ethernet/ti/cpsw_ale.c | 16 ++++++
drivers/net/ethernet/ti/cpsw_ale.h | 2 +
3 files changed, 94 insertions(+), 25 deletions(-)
diff --git a/drivers/net/ethernet/ti/cpsw.c b/drivers/net/ethernet/ti/cpsw.c
index e8bb77d..21bbdcb 100644
--- a/drivers/net/ethernet/ti/cpsw.c
+++ b/drivers/net/ethernet/ti/cpsw.c
@@ -541,14 +541,89 @@ static inline int cpsw_get_slave_port(struct cpsw_priv *priv, u32 slave_num)
return slave_num;
}
+static void cpsw_set_promiscious(struct net_device *ndev, bool enable)
+{
+ struct cpsw_priv *priv = netdev_priv(ndev);
+ struct cpsw_ale *ale = priv->ale;
+
+ if (priv->data.dual_emac) {
+ /* Enabling promiscuous mode for one interface will be
+ * common for both the interface as the interface shares
+ * the same hardware resource.
+ */
+ if (!enable && ((priv->slaves[0].ndev->flags & IFF_PROMISC) ||
+ (priv->slaves[1].ndev->flags & IFF_PROMISC))) {
+ enable = true;
+ dev_err(&ndev->dev, "promiscuity not disabled as the other interface is still in promiscuity mode\n");
+ }
+
+ if (enable) {
+ /* Enable Bypass */
+ cpsw_ale_control_set(ale, 0, ALE_BYPASS, 1);
+
+ dev_dbg(&ndev->dev, "promiscuity enabled\n");
+ } else {
+ /* Disable Bypass */
+ cpsw_ale_control_set(ale, 0, ALE_BYPASS, 0);
+ dev_dbg(&ndev->dev, "promiscuity disabled\n");
+ }
+ } else {
+ int i;
+
+ if (enable) {
+ unsigned long timeout = jiffies + HZ;
+
+ /* Disable Learn for all ports */
+ for (i = 0; i <= priv->data.slaves; i++) {
+ cpsw_ale_control_set(ale, i,
+ ALE_PORT_NOLEARN, 1);
+ cpsw_ale_control_set(ale, i,
+ ALE_PORT_NO_SA_UPDATE, 1);
+ }
+
+ /* Clear All Untouched entries */
+ cpsw_ale_control_set(ale, 0, ALE_AGEOUT, 1);
+ do {
+ cpu_relax();
+ if (cpsw_ale_control_get(ale, 0, ALE_AGEOUT))
+ break;
+ } while (time_after(timeout, jiffies));
+ cpsw_ale_control_set(ale, 0, ALE_AGEOUT, 1);
+
+ /* Clear all mcast from ALE */
+ cpsw_ale_flush_multicast(ale, ALE_ALL_PORTS <<
+ priv->host_port);
+
+ /* Flood All Unicast Packets to Host port */
+ cpsw_ale_control_set(ale, 0, ALE_P0_UNI_FLOOD, 1);
+ dev_dbg(&ndev->dev, "promiscuity enabled\n");
+ } else {
+ /* Flood All Unicast Packets to Host port */
+ cpsw_ale_control_set(ale, 0, ALE_P0_UNI_FLOOD, 0);
+
+ /* Enable Learn for all ports */
+ for (i = 0; i <= priv->data.slaves; i++) {
+ cpsw_ale_control_set(ale, i,
+ ALE_PORT_NOLEARN, 0);
+ cpsw_ale_control_set(ale, i,
+ ALE_PORT_NO_SA_UPDATE, 0);
+ }
+ dev_dbg(&ndev->dev, "promiscuity disabled\n");
+ }
+ }
+}
+
static void cpsw_ndo_set_rx_mode(struct net_device *ndev)
{
struct cpsw_priv *priv = netdev_priv(ndev);
if (ndev->flags & IFF_PROMISC) {
/* Enable promiscuous mode */
- dev_err(priv->dev, "Ignoring Promiscuous mode\n");
+ cpsw_set_promiscious(ndev, true);
return;
+ } else {
+ /* Disable promiscuous mode */
+ cpsw_set_promiscious(ndev, false);
}
/* Clear all mcast from ALE */
@@ -1257,29 +1332,6 @@ fail:
return NETDEV_TX_BUSY;
}
-static void cpsw_ndo_change_rx_flags(struct net_device *ndev, int flags)
-{
- /*
- * The switch cannot operate in promiscuous mode without substantial
- * headache. For promiscuous mode to work, we would need to put the
- * ALE in bypass mode and route all traffic to the host port.
- * Subsequently, the host will need to operate as a "bridge", learn,
- * and flood as needed. For now, we simply complain here and
- * do nothing about it :-)
- */
- if ((flags & IFF_PROMISC) && (ndev->flags & IFF_PROMISC))
- dev_err(&ndev->dev, "promiscuity ignored!\n");
-
- /*
- * The switch cannot filter multicast traffic unless it is configured
- * in "VLAN Aware" mode. Unfortunately, VLAN awareness requires a
- * whole bunch of additional logic that this driver does not implement
- * at present.
- */
- if ((flags & IFF_ALLMULTI) && !(ndev->flags & IFF_ALLMULTI))
- dev_err(&ndev->dev, "multicast traffic cannot be filtered!\n");
-}
-
#ifdef CONFIG_TI_CPTS
static void cpsw_hwtstamp_v1(struct cpsw_priv *priv)
@@ -1575,7 +1627,6 @@ static const struct net_device_ops cpsw_netdev_ops = {
.ndo_open = cpsw_ndo_open,
.ndo_stop = cpsw_ndo_stop,
.ndo_start_xmit = cpsw_ndo_start_xmit,
- .ndo_change_rx_flags = cpsw_ndo_change_rx_flags,
.ndo_set_mac_address = cpsw_ndo_set_mac_address,
.ndo_do_ioctl = cpsw_ndo_ioctl,
.ndo_validate_addr = eth_validate_addr,
diff --git a/drivers/net/ethernet/ti/cpsw_ale.c b/drivers/net/ethernet/ti/cpsw_ale.c
index 63e9819..7f89306 100644
--- a/drivers/net/ethernet/ti/cpsw_ale.c
+++ b/drivers/net/ethernet/ti/cpsw_ale.c
@@ -477,6 +477,14 @@ static const struct ale_control_info ale_controls[ALE_NUM_CONTROLS] = {
.port_shift = 0,
.bits = 1,
},
+ [ALE_P0_UNI_FLOOD] = {
+ .name = "port0_unicast_flood",
+ .offset = ALE_CONTROL,
+ .port_offset = 0,
+ .shift = 8,
+ .port_shift = 0,
+ .bits = 1,
+ },
[ALE_VLAN_NOLEARN] = {
.name = "vlan_nolearn",
.offset = ALE_CONTROL,
@@ -573,6 +581,14 @@ static const struct ale_control_info ale_controls[ALE_NUM_CONTROLS] = {
.port_shift = 0,
.bits = 1,
},
+ [ALE_PORT_NO_SA_UPDATE] = {
+ .name = "no_source_update",
+ .offset = ALE_PORTCTL,
+ .port_offset = 4,
+ .shift = 5,
+ .port_shift = 0,
+ .bits = 1,
+ },
[ALE_PORT_MCAST_LIMIT] = {
.name = "mcast_limit",
.offset = ALE_PORTCTL,
diff --git a/drivers/net/ethernet/ti/cpsw_ale.h b/drivers/net/ethernet/ti/cpsw_ale.h
index 30daa12..de409c3 100644
--- a/drivers/net/ethernet/ti/cpsw_ale.h
+++ b/drivers/net/ethernet/ti/cpsw_ale.h
@@ -34,6 +34,7 @@ enum cpsw_ale_control {
ALE_ENABLE,
ALE_CLEAR,
ALE_AGEOUT,
+ ALE_P0_UNI_FLOOD,
ALE_VLAN_NOLEARN,
ALE_NO_PORT_VLAN,
ALE_OUI_DENY,
@@ -47,6 +48,7 @@ enum cpsw_ale_control {
ALE_PORT_DROP_UNTAGGED,
ALE_PORT_DROP_UNKNOWN_VLAN,
ALE_PORT_NOLEARN,
+ ALE_PORT_NO_SA_UPDATE,
ALE_PORT_UNKNOWN_VLAN_MEMBER,
ALE_PORT_UNKNOWN_MCAST_FLOOD,
ALE_PORT_UNKNOWN_REG_MCAST_FLOOD,
--
1.8.5.2.233.g932f7e4
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
