Add pinctrl section and cd-gpio to mmc1. Without these the SD card is not working on EVM-SK board. Signed-off-by: Peter Ujfalusi <peter.ujfalusi@xxxxxx> --- arch/arm/boot/dts/am335x-evmsk.dts | 9 +++++++++ 1 file changed, 9 insertions(+) diff --git a/arch/arm/boot/dts/am335x-evmsk.dts b/arch/arm/boot/dts/am335x-evmsk.dts index 50abe53f6887..486880b74831 100644 --- a/arch/arm/boot/dts/am335x-evmsk.dts +++ b/arch/arm/boot/dts/am335x-evmsk.dts @@ -256,6 +256,12 @@ >; }; + mmc1_pins: pinmux_mmc1_pins { + pinctrl-single,pins = < + 0x160 (PIN_INPUT | MUX_MODE7) /* spi0_cs1.gpio0_6 */ + >; + }; + mcasp1_pins: mcasp1_pins { pinctrl-single,pins = < 0x10c (PIN_INPUT_PULLDOWN | MUX_MODE4) /* mii1_crs.mcasp1_aclkx */ @@ -456,6 +462,9 @@ status = "okay"; vmmc-supply = <&vmmc_reg>; bus-width = <4>; + pinctrl-names = "default"; + pinctrl-0 = <&mmc1_pins>; + cd-gpios = <&gpio0 6 GPIO_ACTIVE_HIGH>; }; &sham { -- 1.8.5.2 -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html