Quoting Tero Kristo (2013-11-26 00:05:41) > Hi, > Hi Tero, Thanks for your long suffering patience on this series. The clock patches look very good to me with exception of a few small comments. Let me know how I can help with the hierarchal DT stuff since I think that has been the gating factor for this series for the past few revisions. > Changes compared to v9: > - rebased on top of 3.13-rc1 > - modified the low level clk register API to provide SoC specific clk_readl > and clk_writel support which can be registered during boot, TI SoC variant > uses regmap on low level Regarding regmap, will that be dropped for V11? I don't care whether it stays or goes but the approach you took is probably too top-level. Patch #1 sets clk_reg_ops system-wide which probably isn't right. Different clock drivers might compete to set those ops and the last one to write wins. A better approach is to support regmap ops on a per-clock basis (for clocks that use the generic implementations like clk-divider and clk-gate; obviously this is overkill for entirely hardware-specific clocks). Stephen Boyd's approach is a better solution[1][2] but unfortunately that approach dumps crap into struct clk_hw which is bad. Anyways if you decide against regmap for V11 then the whole issue is avoided. Regards, Mike [1] http://article.gmane.org/gmane.linux.ports.arm.kernel/273742 [2] http://article.gmane.org/gmane.linux.ports.arm.kernel/273744 > - dropped regmap parameter from clock init calls, instead a helper is used > for getting regmap index along with the register offset from DT > - dropped regmap parameter from clock structs, instead platform specific > clk_readl / clk_writel are used to parse reg parameter according to > platform, for TI SoC:s, this is encoded as: > struct clk_omap_reg { > u16 offset; /* register offset */ > u16 index; /* regmap index */ > } > - Nishanth's comments to v9 mostly addressed, except for the CLK_OF_DECLARE > tweak which I would actually want some feedback upon, basically the problem > is I need to return status from the clk init functions so I can see if > -EAGAIN is passed, in which case init will be retried later, maybe some of > this can be made generic, like converting all the CLK_OF_DECLARE type > functions to return status > > Testing done: > - omap3-beagle : boot + suspend/resume > - omap3-beagle-xm : boot (thanks to Nishanth) > - omap4-panda-es : boot + suspend/resume > - omap5-uevm : boot > - dra7-evm : boot > - am335x-bone : boot > > Separate branches available at https://github.com/t-kristo/linux-pm.git > > - full: 3.13-rc1-dt-clks-v10 (should be merged last, contains everything) > - clk driver only: 3.13-rc1-dt-clks-v10-for-mike > - DT data only: 3.13-rc1-dt-clks-v10-for-benoit > > -Tero > -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
