* Balaji T K <balajitk@xxxxxx> [131210 02:17]: > Add pbias regulator node as a child of system control > module - syscon. > > Signed-off-by: Balaji T K <balajitk@xxxxxx> > --- > arch/arm/boot/dts/dra7.dtsi | 14 ++++++++++++++ > arch/arm/boot/dts/omap2430.dtsi | 14 ++++++++++++++ > arch/arm/boot/dts/omap3.dtsi | 14 ++++++++++++++ > arch/arm/boot/dts/omap4.dtsi | 14 ++++++++++++++ > arch/arm/boot/dts/omap5.dtsi | 14 ++++++++++++++ > 5 files changed, 70 insertions(+), 0 deletions(-) > > diff --git a/arch/arm/boot/dts/dra7.dtsi b/arch/arm/boot/dts/dra7.dtsi > index d0df4c4..1a52676 100644 > --- a/arch/arm/boot/dts/dra7.dtsi > +++ b/arch/arm/boot/dts/dra7.dtsi > @@ -119,6 +119,19 @@ > pinctrl-single,function-mask = <0x3fffffff>; > }; > > + tisyscon: tisyscon@4A100600 { > + compatible = "ti,control-syscon", "syscon", "simple-bus"; > + reg = <0x4A002E00 0x4>; This should map the whole GENERAL area of the SCM register space instead in one or multiple sections or driver instances. This way the same driver can be used for the misc SCM registers from other drivers. If you don't define it that way now, you'll end up with broken child driver offsets in the .dts files later on. > + pbias_regulator: pbias_regulator { > + compatible = "regulator-pbias-omap5"; > + pbias-reg-offset = <0>; > + regulator-name = "pbias_regulator"; > + regulator-min-microvolt = <1800000>; > + regulator-max-microvolt = <3000000>; > + regulator-enable-ramp-delay = <10>; Then the pbias_regulator needs to have the standard reg property as an offset from the SCM GENERAL base address. Regards, Tony -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html