Adrian Hunter wrote:
From 410bc62034c021f8767c8dae469c3215783992ca Mon Sep 17 00:00:00 2001
From: Adrian Hunter <ext-adrian.hunter@xxxxxxxxx>
Date: Mon, 12 Jan 2009 16:13:08 +0200
Subject: [PATCH] OMAP: HSMMC: Fix response type for busy after response
Some MMC commands result in the card becoming busy after
the response is received. This needs to be specified
for the omap_hsmmc host controller, which is what this
patch does. However, the effect is that some commands
with no data will cause a Transfer Complete (TC) interrupt
in addition to the Command Complete (CC) interrupt.
In order to deal with that, the irq handler has needed
a few changes also.
The benefit of this change is that the omap_hsmmc host
controller driver now waits for the TC interrupt while
the card is busy, so the mmc_block driver needs to poll
the card status just once instead of repeatedly.
i.e. the net result is more sleep and less cpu.
This also fixes the hidden problem that the controller
was turning off the clock to the card while the card
was busy - the clock was then switched on for the
duration of each Send Status command used for polling,
which is why writes did not lock up altogether.
i.e. really dysfunctional.
That paragraph is not true. According to the standard:
"The host is allowed to shut down the clock of a “busy” card. The card will complete the programming
operation regardless of the host clock. However, the host must provide a clock edge for the card to turn
off its busy signal. Without a clock edge the card (unless previously disconnected by a deselect command
-CMD7) will force the DAT0 line down, forever."
i.e. during busy state the clock is only needed to check whether the busy state is over.
I will resend the patch, without that paragraph and with a fix to report the
error code when there is a timeout error in the busy state.
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
