Hi,
I am trying out suspend, resume on an OMAP3 based board. What I see during resume is that the SMC911x driver resume routing gets stuck after trying to transmit the packet out of the controller. Some debug messages below:
--> smc911x_drv_resume
eth0: --> smc911x_reset
eth0: smc911x_reset timeout waiting for PM restore
eth0: --> smc911x_enable
eth0: --> smc911x_phy_configure()
eth0: --> smc911x_phy_reset()
eth0: phy caps=0x782d
eth0: phy advertised caps=0x0de1
eth0: --> smc911x_phy_check_media
smc911x_phy_read: phyaddr=0x1, phyreg=0x01, phydata=0x7809
smc911x_phy_read: phyaddr=0x1, phyreg=0x01, phydata=0x7809
eth0: link down
Restarting tasks ... eth0: --> smc911x_hard_start_xmit
eth0: --> smc911x_hardware_send_pkt
eth0: --> smc911x_hard_start_xmit
eth0: --> smc911x_hardware_send_pkt
eth0: --> smc911x_hard_start_xmit
eth0: --> smc911x_hardware_send_pkt
nfs: server 172.24.190.217 not responding, still trying
nfs: server 172.24.190.217 not responding, still trying
The following change makes it work fine: (The change within smc911x_drv_probe function was to get rid of a compilation warning).
Additionally, the SMC9211 data sheet says that when we enter D2 sleep state, we need to set the EDPWRDOWN bit in the PHY Mode control/status register and clear it when we are back to D0. This is not done in the code as far as I can see. So does it mean that the PHY is not powered down but the controller is? I have another patch that fixes it. I will send that as well unless I am missing something.
Thanks,
-Romit
Signed-off-by: Romit Dasgupta <romit@xxxxxx>
diff --git a/drivers/net/smc911x.c b/drivers/net/smc911x.c
index 5051554..1f26ab0 100644
--- a/drivers/net/smc911x.c
+++ b/drivers/net/smc911x.c
@@ -2050,7 +2050,9 @@ err_out:
*/
static int smc911x_drv_probe(struct platform_device *pdev)
{
+#ifdef SMC_DYNAMIC_BUS_CONFIG
struct smc911x_platdata *pd = pdev->dev.platform_data;
+#endif
struct net_device *ndev;
struct resource *res;
struct smc911x_local *lp;
@@ -2182,9 +2184,9 @@ static int smc911x_drv_resume(struct platform_device *dev)
if (netif_running(ndev)) {
smc911x_reset(ndev);
- smc911x_enable(ndev);
if (lp->phy_type != 0)
smc911x_phy_configure(&lp->phy_configure);
+ smc911x_enable(ndev);
netif_device_attach(ndev);
}
}
--
To unsubscribe from this list: send the line "unsubscribe linux-omap" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
