On Tuesday 30 September 2008, Gadiyar, Anand wrote: > From: Anand Gadiyar <gadiyar@xxxxxx> > > Add pin-mux settings for OHCI in PHY mode. > Also change settings for EHCI in TLL mode. > > Signed-off-by: Anand Gadiyar <gadiyar@xxxxxx> > --- > Fixed comments below. Also fixed one pin that should > have been marked output, but was wrongly marked input. > > arch/arm/mach-omap2/mux.c | 67 +++++++++++++++++++++++++++------- > arch/arm/plat-omap/include/mach/mux.h | 26 ++++++++++++- > 2 files changed, 80 insertions(+), 13 deletions(-) I didn't see anything obvious to complain about, but then I've not delved deeply into OMAP3 EHCI. Were you the person who was looking to package the PHY/TLL mode setup in platform data? Any progress on that? (I added EHCI to my Beagle/Overo config, and it came up with all kinds of nonsense on the Beagle. Configured several ports, not just one, and in fact this board does not even *have* the EHCI transceiver. So it was very obvious that EHCI setup wasn't right yet. That's even apart from the messaging goofs, which have trivial fixes I'll send along in a while.) - dave -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
