On Fri, Mar 03, 2017 at 05:46:05PM -0500, Olga Kornievskaia wrote: > > > On Mar 3, 2017, at 4:32 PM, J. Bruce Fields <bfields@xxxxxxxxxxxx> wrote: > > > > On Fri, Mar 03, 2017 at 04:08:19PM -0500, Olga Kornievskaia wrote: > >> > >>> On Mar 3, 2017, at 3:47 PM, J. Bruce Fields <bfields@xxxxxxxxxxxx> wrote: > >>> > >>> On Thu, Mar 02, 2017 at 08:22:21AM -0800, Christoph Hellwig wrote: > >>>> On Thu, Mar 02, 2017 at 11:01:05AM -0500, Olga Kornievskaia wrote: > >>>>> + if (pos_in >= i_size_read(inode_in)) > >>>>> + return -EINVAL; > >>>> > >>>> That's not how the syscall is supposed to work, we'd rather do a > >>>> short read^^^^^copy. > >>> > >>> That's what I think too, but then is COPY(2) wrong?: > >>> > >>> EINVAL Requested range extends beyond the end of the source > >>> file; or the flags argument is not 0. > >>> > >>> Also, copy_file_range can be implemented by ->clone_file_range, where > >>> these kinds of checks make more sense, I think; e.g. from btrfs: > >>> > >>> ret = -EINVAL; > >>> if (off + len > src->i_size || off + len < off) > >>> goto out_unlock; > >>> > >>> Well, so the caller just has to be prepared for either behavior, I > >>> guess, but that may make it more complicated to use. > >>> > >> > >> I’m still rather very confused again by the comment and what it is proposing. > >> > >> There are two checks to consider for the validity of the arguments > >> > >> 1. If the offset of the source file is beyond the end of the source file. > >> 2. If the offset + len is beyond the end of the file. > >> > >> I read that the man page is talking about #2. This is actually what the NFSv4.2 spec required for the COPY too but we’ve been discussing that it should be a short read instead. > >> > >> This patch address is to address case #1. As far as I can tell it applies to all file systems. > >> > >> Are you suggesting that the checks for the validity of the arguments do not belong in VFS but instead should be in each of the underlying file systems? > >> > >> Not all vfs_copy_file_range() are implemented via clone_file_range(). At least I hope that “inter” NFSv4.2 COPY will also use vfs_file_copy_range() and it would not be calling clone(). > > > > I think it'd be acceptable for copy_file_range() to just return 0 even > > in your case 1. I believe that's what ordinary read and pread does. > > > > You probably can't perform it atomically with the copy, so it's possible > > that the size will change right after you check it. > > > > I don't see a benefit to the check. > > In read() you don’t specify the offset from which to read. It is read > from the current file descriptor offset. I don’t find the comparison > equal. > > It’s it more fair to compare it to lseek() which does return EINVAL if > you specify position beyond the end of the file. Or pread(), which takes an offset. But read() can read at an offset at the end of file, or even past that (if the file was truncated), and I believe it just returns 0 in those cases. --b. -- To unsubscribe from this list: send the line "unsubscribe linux-nfs" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
