Good morning! Summary on the X200: - First resume after suspend takes 20 seconds - Further resumes work fine - wlan works *before* first suspend and wakeup - after that the same happens as on 2.6.29-rc3-ikn-00697-gae1a25d: the device refuses to come up with the message "iwlagn: Could not load the INST uCode section" and "iwlagn: Unable to set up bootstrap uCode: -110" Dmesg before suspend: Feb 9 21:18:06 ikn kernel: [ 9.535291] iwlagn: Intel(R) Wireless WiFi Link AGN driver for Linux, 1.3.27ks Feb 9 21:18:06 ikn kernel: [ 9.535469] iwlagn: Copyright(c) 2003-2008 Intel Corporation Feb 9 21:18:06 ikn kernel: [ 9.535653] iwlagn 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17 Feb 9 21:18:06 ikn kernel: [ 9.535774] iwlagn 0000:03:00.0: setting latency timer to 64 Feb 9 21:18:06 ikn kernel: [ 9.535807] iwlagn: Detected Intel Wireless WiFi Link 5300AGN REV=0x24 Feb 9 21:18:06 ikn kernel: [ 9.554784] iwlagn: Tunable channels: 13 802.11bg, 24 802.11a channels Feb 9 21:18:06 ikn kernel: [ 9.555464] iwlagn 0000:03:00.0: PCI INT A disabled Feb 9 21:18:06 ikn kernel: [ 9.563121] wmaster0 (iwlagn): not using net_device_ops yet Feb 9 21:18:06 ikn kernel: [ 9.563784] phy0: Selected rate control algorithm 'iwl-agn-rs' Feb 9 21:18:06 ikn kernel: [ 9.857164] wlan0 (iwlagn): not using net_device_ops yet Feb 9 21:18:20 ikn kernel: [ 62.784153] iwlagn 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17 Feb 9 21:18:20 ikn kernel: [ 62.784381] iwlagn 0000:03:00.0: restoring config space at offset 0x1 (was 0x100102, writing 0x100106) Feb 9 21:18:20 ikn kernel: [ 62.784495] iwlagn 0000:03:00.0: irq 29 for MSI/MSI-X Feb 9 21:18:20 ikn kernel: [ 62.784580] iwlagn 0000:03:00.0: firmware: requesting iwlwifi-5000-1.ucode Feb 9 21:18:20 ikn kernel: [ 62.936982] iwlagn loaded firmware version 5.4.1.16 Feb 9 21:18:20 ikn kernel: [ 62.938427] iwlagn: Radio disabled by HW RF Kill switch Feb 9 21:18:20 ikn kernel: [ 62.950596] ADDRCONF(NETDEV_UP): wlan0: link is not ready Feb 9 21:19:21 ikn kernel: [ 124.407490] wlan0: direct probe to AP 00:14:6c:67:9c:32 try 1 Feb 9 21:19:21 ikn kernel: [ 124.410724] wlan0 direct probe responded Feb 9 21:19:21 ikn kernel: [ 124.410730] wlan0: authenticate with AP 00:14:6c:67:9c:32 Feb 9 21:19:21 ikn kernel: [ 124.412782] wlan0: authenticated Feb 9 21:19:21 ikn kernel: [ 124.412787] wlan0: associate with AP 00:14:6c:67:9c:32 Feb 9 21:19:21 ikn kernel: [ 124.420641] wlan0: RX AssocResp from 00:14:6c:67:9c:32 (capab=0x601 status=0 aid=9) Feb 9 21:19:21 ikn kernel: [ 124.420647] wlan0: associated Feb 9 21:19:21 ikn kernel: [ 124.425527] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready Feb 9 21:19:32 ikn kernel: [ 134.452077] wlan0: no IPv6 routers present Dmesg after suspend: [ 569.004130] iwlagn: Could not load the INST uCode section [ 569.004135] iwlagn: Unable to set up bootstrap uCode: -110 [ 574.004128] iwlagn: Could not load the INST uCode section [ 574.004132] iwlagn: Unable to set up bootstrap uCode: -110 [ 579.004139] iwlagn: Could not load the INST uCode section [ 579.004143] iwlagn: Unable to set up bootstrap uCode: -110 [ 584.004128] iwlagn: Could not load the INST uCode section [ 584.004132] iwlagn: Unable to set up bootstrap uCode: -110 [ 589.004139] iwlagn: Could not load the INST uCode section [ 589.004143] iwlagn: Unable to set up bootstrap uCode: -110 [ 589.013376] iwlagn: Unable to initialize device after 5 attempts. [ 589.013469] iwlagn 0000:03:00.0: PCI INT A disabled [ 589.014080] sd 0:0:0:0: [sda] Starting disk [ 590.528142] usb 7-6: reset high speed USB device using ehci_hcd and address 3 [ 590.776137] usb 8-6: reset high speed USB device using ehci_hcd and address 2 [ 591.032124] usb 2-1: reset full speed USB device using uhci_hcd and address 2 [ 591.183383] pci 0000:00:02.0: power state changed by ACPI to D0 [ 591.183416] pci 0000:00:02.0: restoring config space at offset 0x1 (was 0x900403, writing 0x900003) [ 591.183582] pci 0000:00:02.0: power state changed by ACPI to D0 [ 591.183594] pci 0000:00:02.0: setting latency timer to 64 [ 591.200209] Restarting tasks ... done. [ 592.305888] elantech.c: unexpected magic knock result 0x00, 0x02, 0x64. [ 592.629437] IBM TrackPoint firmware: 0x0e, buttons: 3/3 [ 592.647485] input: TPPS/2 IBM TrackPoint as /class/input/input11 [ 593.200148] wlan0: No ProbeResp from current AP 00:14:6c:67:9c:32 - assume out of range [ 611.582358] wlan0: direct probe to AP 00:14:6c:67:9c:32 try 1 [ 611.780126] wlan0: direct probe to AP 00:14:6c:67:9c:32 try 2 [ 611.980122] wlan0: direct probe to AP 00:14:6c:67:9c:32 try 3 [ 612.180163] wlan0: direct probe to AP 00:14:6c:67:9c:32 timed out Nico -- Think about Free and Open Source Software (FOSS). http://nico.schottelius.org/documentations/foss/the-term-foss/ PGP: BFE4 C736 ABE5 406F 8F42 F7CF B8BE F92A 9885 188C
Attachment:
signature.asc
Description: Digital signature
