Hi Randy, > # CONFIG_MTD_LPDDR is not set > CONFIG_MTD_QINFO_PROBE=y > > There appears to be too little control/coordination between those > two kconfig symbols. Surely one of them (MTD_QINFO_PROBE) should > depend on the other (MTD_LPDDR). And why even build 2 modules > when MTD_QINFO_PROBE is enabled? Why not combine the code into > one module? Thanks a lot for good finding. Here is a fix for the problem. About combining: it is assumed to have one QINFO probing module for several kinds of LPDDR command set drivers. If we combine two modules into one it would make further extension rather hard. So it is better to have two modules. To fix a problem I just added dependency in Kconfig file. This temporary fix which will work until we have just one cmdset module. In near future we will make a fix which parse command set types and select proper driver according to device type. Thanks, Alexey Signed-off-by: Alexey Korolev <akorolev@xxxxxxxxxxxxx> --- diff --git a/drivers/mtd/lpddr/Kconfig b/drivers/mtd/lpddr/Kconfig index acd4ea9..5a401d8 100644 --- a/drivers/mtd/lpddr/Kconfig +++ b/drivers/mtd/lpddr/Kconfig @@ -12,6 +12,7 @@ config MTD_LPDDR DDR memories, intended for battery-operated systems. config MTD_QINFO_PROBE + depends on MTD_LPDDR tristate "Detect flash chips by QINFO probe" help Device Information for LPDDR chips is offered through the Overlay -- To unsubscribe from this list: send the line "unsubscribe linux-next" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html