SFLASHC_BURST_CFG is only available on older ipq nand platforms, this register has been removed when the NAND controller is moved as part of qpic controller. Avoid writing this register on devices which are based on qpic NAND controller. Fixes: dce84760 (mtd: nand: qcom: Support for IPQ8074 QPIC NAND controller) Cc: stable@xxxxxxxxxxxxxxx Signed-off-by: Sivaprakash Murugesan <sivaprak@xxxxxxxxxxxxxx> --- drivers/mtd/nand/raw/qcom_nandc.c | 7 ++++++- 1 file changed, 6 insertions(+), 1 deletion(-) diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c index f1daf33..78b5f21 100644 --- a/drivers/mtd/nand/raw/qcom_nandc.c +++ b/drivers/mtd/nand/raw/qcom_nandc.c @@ -459,11 +459,13 @@ struct qcom_nand_host { * among different NAND controllers. * @ecc_modes - ecc mode for NAND * @is_bam - whether NAND controller is using BAM + * @is_qpic - whether NAND CTRL is part of qpic IP * @dev_cmd_reg_start - NAND_DEV_CMD_* registers starting offset */ struct qcom_nandc_props { u32 ecc_modes; bool is_bam; + bool is_qpic; u32 dev_cmd_reg_start; }; @@ -2774,7 +2776,8 @@ static int qcom_nandc_setup(struct qcom_nand_controller *nandc) u32 nand_ctrl; /* kill onenand */ - nandc_write(nandc, SFLASHC_BURST_CFG, 0); + if (!nandc->props->is_qpic) + nandc_write(nandc, SFLASHC_BURST_CFG, 0); nandc_write(nandc, dev_cmd_reg_addr(nandc, NAND_DEV_CMD_VLD), NAND_DEV_CMD_VLD_VAL); @@ -3035,12 +3038,14 @@ static const struct qcom_nandc_props ipq806x_nandc_props = { static const struct qcom_nandc_props ipq4019_nandc_props = { .ecc_modes = (ECC_BCH_4BIT | ECC_BCH_8BIT), .is_bam = true, + .is_qpic = true, .dev_cmd_reg_start = 0x0, }; static const struct qcom_nandc_props ipq8074_nandc_props = { .ecc_modes = (ECC_BCH_4BIT | ECC_BCH_8BIT), .is_bam = true, + .is_qpic = true, .dev_cmd_reg_start = 0x7000, }; -- 2.7.4 ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/