Implemented ECC correctable and uncorrectable error handling for EDU reads. If ECC correctable bitflips are encountered on EDU transfer, read page again using pio, This is needed due to a controller lmitation where read and corrected data is not transferred to the DMA buffer on ECC errors. This holds true for ECC correctable errors beyond set threshold. Fixes: a5d53ad26a8b ("mtd: rawnand: brcmnand: Add support for flash-edu for dma transfers") Signed-off-by: Kamal Dasu <kdasu.kdev@xxxxxxxxx> --- drivers/mtd/nand/raw/brcmnand/brcmnand.c | 26 ++++++++++++++++++++++++ 1 file changed, 26 insertions(+) diff --git a/drivers/mtd/nand/raw/brcmnand/brcmnand.c b/drivers/mtd/nand/raw/brcmnand/brcmnand.c index 0c1d6e543586..d7daa83c8a58 100644 --- a/drivers/mtd/nand/raw/brcmnand/brcmnand.c +++ b/drivers/mtd/nand/raw/brcmnand/brcmnand.c @@ -1855,6 +1855,22 @@ static int brcmnand_edu_trans(struct brcmnand_host *host, u64 addr, u32 *buf, edu_writel(ctrl, EDU_STOP, 0); /* force stop */ edu_readl(ctrl, EDU_STOP); + if (ret == 0 && edu_cmd == EDU_CMD_READ) { + u64 err_addr = 0; + + /* + * check for ecc errors here, subpage ecc erros are + * retained in ecc error addr register + */ + err_addr = brcmnand_get_uncorrecc_addr(ctrl); + if (!err_addr) { + err_addr = brcmnand_get_correcc_addr(ctrl); + if (err_addr) + ret = -EUCLEAN; + } else + ret = -EBADMSG; + } + return ret; } @@ -2058,6 +2074,7 @@ static int brcmnand_read(struct mtd_info *mtd, struct nand_chip *chip, u64 err_addr = 0; int err; bool retry = true; + bool edu_read = false; dev_dbg(ctrl->dev, "read %llx -> %p\n", (unsigned long long)addr, buf); @@ -2075,6 +2092,10 @@ static int brcmnand_read(struct mtd_info *mtd, struct nand_chip *chip, else return -EIO; } + + if (has_edu(ctrl)) + edu_read = true; + } else { if (oob) memset(oob, 0x99, mtd->oobsize); @@ -2122,6 +2143,11 @@ static int brcmnand_read(struct mtd_info *mtd, struct nand_chip *chip, if (mtd_is_bitflip(err)) { unsigned int corrected = brcmnand_count_corrected(ctrl); + /* in case of edu correctable error we read again using pio */ + if (edu_read) + err = brcmnand_read_by_pio(mtd, chip, addr, trans, buf, + oob, &err_addr); + dev_dbg(ctrl->dev, "corrected error at 0x%llx\n", (unsigned long long)err_addr); mtd->ecc_stats.corrected += corrected; -- 2.17.1 ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/