1. SFLASHC_BURST_CFG register is not available on all ipq nand platforms, it is available only on ipq8064 devices and the nand controller works without configuring these registers in this platform, so register write to this can be removed. 2. Once BAM mode is enabled register writes to NAND_CTRL should be performed through BAM command descriptors. The NAND BAM mode will be enabled by bootloaders. Check if BAM mode is already enabled and enable it only if not enabled already. Signed-off-by: Sivaprakash Murugesan <sivaprak@xxxxxxxxxxxxxx> --- drivers/mtd/nand/raw/qcom_nandc.c | 11 ++++++++--- 1 file changed, 8 insertions(+), 3 deletions(-) diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c index 5b11c70..7bfd93a 100644 --- a/drivers/mtd/nand/raw/qcom_nandc.c +++ b/drivers/mtd/nand/raw/qcom_nandc.c @@ -36,7 +36,6 @@ #define NAND_DEV_CMD1 0xa4 #define NAND_DEV_CMD2 0xa8 #define NAND_DEV_CMD_VLD 0xac -#define SFLASHC_BURST_CFG 0xe0 #define NAND_ERASED_CW_DETECT_CFG 0xe8 #define NAND_ERASED_CW_DETECT_STATUS 0xec #define NAND_EBI2_ECC_BUF_CFG 0xf0 @@ -2774,14 +2773,20 @@ static int qcom_nandc_setup(struct qcom_nand_controller *nandc) u32 nand_ctrl; /* kill onenand */ - nandc_write(nandc, SFLASHC_BURST_CFG, 0); nandc_write(nandc, dev_cmd_reg_addr(nandc, NAND_DEV_CMD_VLD), NAND_DEV_CMD_VLD_VAL); /* enable ADM or BAM DMA */ if (nandc->props->is_bam) { nand_ctrl = nandc_read(nandc, NAND_CTRL); - nandc_write(nandc, NAND_CTRL, nand_ctrl | BAM_MODE_EN); + /* Once BAM_MODE_EN bit is set, writes to the NAND_CTRL + * should be done through BAM command descriptors. + * in most cases bootloader enables the bam mode we + * need to set the BAM mode only if it is not set by + * bootloader + */ + if (!(nand_ctrl & BAM_MODE_EN)) + nandc_write(nandc, NAND_CTRL, nand_ctrl | BAM_MODE_EN); } else { nandc_write(nandc, NAND_FLASH_CHIP_SELECT, DM_EN); } -- 2.7.4 ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/