Those properties are no longer parsed by the driver which is being passed those information by the core now. Let's deprecate them. Signed-off-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx> --- Documentation/devicetree/bindings/mtd/fsl-upm-nand.txt | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) diff --git a/Documentation/devicetree/bindings/mtd/fsl-upm-nand.txt b/Documentation/devicetree/bindings/mtd/fsl-upm-nand.txt index fce4894f5a98..25f07c1f9e44 100644 --- a/Documentation/devicetree/bindings/mtd/fsl-upm-nand.txt +++ b/Documentation/devicetree/bindings/mtd/fsl-upm-nand.txt @@ -7,14 +7,16 @@ Required properties: - fsl,upm-cmd-offset : UPM pattern offset for the command latch. Optional properties: -- fsl,upm-wait-flags : add chip-dependent short delays after running the - UPM pattern (0x1), after writing a data byte (0x2) or after - writing out a buffer (0x4). - fsl,upm-addr-line-cs-offsets : address offsets for multi-chip support. The corresponding address lines are used to select the chip. - gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins (R/B#). For multi-chip devices, "n" GPIO definitions are required according to the number of chips. + +Deprecated properties: +- fsl,upm-wait-flags : add chip-dependent short delays after running the + UPM pattern (0x1), after writing a data byte (0x2) or after + writing out a buffer (0x4). - chip-delay : chip dependent delay for transferring data from array to read registers (tR). Required if property "gpios" is not used (R/B# pins not connected). @@ -52,8 +54,6 @@ upm@3,0 { fsl,upm-cmd-offset = <0x08>; /* Multi-chip NAND device */ fsl,upm-addr-line-cs-offsets = <0x0 0x200>; - fsl,upm-wait-flags = <0x5>; - chip-delay = <25>; // in micro-seconds nand@0 { #address-cells = <1>; -- 2.25.4 ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/