[PATCH v6 07/30] mtd: rawnand: Compare the actual timing values

[Miquel Raynal <miquel.raynal@xxxxxxxxxxx>]

Avoid relying just on the default timing mode to discriminate if the
data interface must be restored. This field should only be used
at initialization time by legacy chips statically defined. Do a
memcmp() instead.

Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
Reviewed-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx>
---
 drivers/mtd/nand/raw/nand_base.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/nand/raw/nand_base.c b/drivers/mtd/nand/raw/nand_base.c
index 534ee75d0f2b..3526c2a50bbe 100644
--- a/drivers/mtd/nand/raw/nand_base.c
+++ b/drivers/mtd/nand/raw/nand_base.c
@@ -2512,7 +2512,8 @@ int nand_reset(struct nand_chip *chip, int chipnr)
 	 * nand_setup_data_interface() uses ->set/get_features() which would
 	 * fail anyway as the parameter page is not available yet.
 	 */
-	if (!chip->onfi_timing_mode_default)
+	if (!memcmp(&chip->data_interface, &saved_data_intf,
+		    sizeof(saved_data_intf)))
 		return 0;
 
 	chip->data_interface = saved_data_intf;
-- 
2.20.1


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/