On Tuesday, May 26, 2020 12:35:59 PM EEST Vignesh Raghavendra wrote: > Drop configuration of Flash size, erase size and page size > configuration. Flash size is needed only if using AHB decoder (BIT 23 of > CONFIG_REG) which is not used by the driver. > Erase size and page size are needed if IP is configured to send WREN > automatically. But since SPI NOR layer takes care of sending WREN, there > is no need to configure these fields either. > > Therefore drop these in preparation to move the driver to spi-mem > framework where flash geometry is not visible to controller driver. > > Signed-off-by: Vignesh Raghavendra <vigneshr@xxxxxx> > --- > .../mtd/spi-nor/controllers/cadence-quadspi.c | 36 +------------------ > 1 file changed, 1 insertion(+), 35 deletions(-) Reviewed-by: Tudor Ambarus <tudor.ambarus@xxxxxxxxxxxxx> ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/