Hi Arnd, Arnd Bergmann <arnd@xxxxxxxx> wrote on Wed, 27 May 2020 15:42:03 +0200: > Like several other nand flash drivers, this one requires the BCH > library to be selected from Kconfig. Actually most of the time these drivers do not depend on BCH directly. Here it is a bit particular: the hardware ECC engine logic being broken, I found a workaround by using BCH's library functions directly to verify the hardware correctness. Anyway, thank you very much for the fix but if I didn't make a mistake it should have been fixed yesterday night already, so it's probably not in linux-next yet. > arm-linux-gnueabi-ld: drivers/mtd/nand/raw/arasan-nand-controller.o: in function `anfc_attach_chip': > arasan-nand-controller.c:(.text+0x894): undefined reference to `bch_init' > arm-linux-gnueabi-ld: drivers/mtd/nand/raw/arasan-nand-controller.o: in function `anfc_detach_chip': > arasan-nand-controller.c:(.text+0x98c): undefined reference to `bch_free' > arm-linux-gnueabi-ld: drivers/mtd/nand/raw/arasan-nand-controller.o: in function `anfc_read_page_hw_ecc': > arasan-nand-controller.c:(.text+0x1080): undefined reference to `bch_decode' > > Fixes: 197b88fecc50 ("mtd: rawnand: arasan: Add new Arasan NAND controller") > Signed-off-by: Arnd Bergmann <arnd@xxxxxxxx> > --- > drivers/mtd/nand/raw/Kconfig | 1 + > 1 file changed, 1 insertion(+) > > diff --git a/drivers/mtd/nand/raw/Kconfig b/drivers/mtd/nand/raw/Kconfig > index e2bc87779bf9..113f61052269 100644 > --- a/drivers/mtd/nand/raw/Kconfig > +++ b/drivers/mtd/nand/raw/Kconfig > @@ -456,6 +456,7 @@ config MTD_NAND_CADENCE > config MTD_NAND_ARASAN > tristate "Support for Arasan NAND flash controller" > depends on HAS_IOMEM && HAS_DMA > + select BCH > help > Enables the driver for the Arasan NAND flash controller on > Zynq Ultrascale+ MPSoC. Thanks, Miquèl ______________________________________________________ Linux MTD discussion mailing list http://lists.infradead.org/mailman/listinfo/linux-mtd/