[RESEND v5 19/21] mtd: nand: Drop useless 'depends on' in Kconfig

[Miquel Raynal <miquel.raynal@xxxxxxxxxxx>]

Both OneNAND and raw NAND bits can't be compiled if MTD is disabled
because of the if/endif logic in drivers/mtd/Kconfig. There is no need
for an extra "depends on MTD" in their respective Kconfig files.

Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
Reviewed-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx>
---
 drivers/mtd/nand/onenand/Kconfig | 1 -
 drivers/mtd/nand/raw/Kconfig     | 1 -
 2 files changed, 2 deletions(-)

diff --git a/drivers/mtd/nand/onenand/Kconfig b/drivers/mtd/nand/onenand/Kconfig
index 572b8fe69abb..1a0e65bc246e 100644
--- a/drivers/mtd/nand/onenand/Kconfig
+++ b/drivers/mtd/nand/onenand/Kconfig
@@ -1,7 +1,6 @@
 # SPDX-License-Identifier: GPL-2.0-only
 menuconfig MTD_ONENAND
 	tristate "OneNAND Device Support"
-	depends on MTD
 	depends on HAS_IOMEM
 	help
 	  This enables support for accessing all type of OneNAND flash
diff --git a/drivers/mtd/nand/raw/Kconfig b/drivers/mtd/nand/raw/Kconfig
index e2bc87779bf9..c534e441ea68 100644
--- a/drivers/mtd/nand/raw/Kconfig
+++ b/drivers/mtd/nand/raw/Kconfig
@@ -12,7 +12,6 @@ config MTD_NAND_ECC_SW_HAMMING_SMC
 
 menuconfig MTD_RAW_NAND
 	tristate "Raw/Parallel NAND Device Support"
-	depends on MTD
 	select MTD_NAND_CORE
 	select MTD_NAND_ECC_SW_HAMMING
 	help
-- 
2.20.1


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/