[PATCH v5 08/28] mtd: rawnand: Use the data interface mode entry when relevant

[Miquel Raynal <miquel.raynal@xxxxxxxxxxx>]

The data interface setup does not care about the default timing mode
but cares about the actual timing mode at the time of the call of this
helper.

Use this entry instead and let chip->default_timing_mode only be used
at initialization time.

Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
Reviewed-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx>
---
 drivers/mtd/nand/raw/nand_base.c | 9 ++++-----
 1 file changed, 4 insertions(+), 5 deletions(-)

diff --git a/drivers/mtd/nand/raw/nand_base.c b/drivers/mtd/nand/raw/nand_base.c
index 7567c973964b..6a6af0b19fec 100644
--- a/drivers/mtd/nand/raw/nand_base.c
+++ b/drivers/mtd/nand/raw/nand_base.c
@@ -951,9 +951,8 @@ static int nand_reset_data_interface(struct nand_chip *chip, int chipnr)
  */
 static int nand_setup_data_interface(struct nand_chip *chip, int chipnr)
 {
-	u8 tmode_param[ONFI_SUBFEATURE_PARAM_LEN] = {
-		chip->onfi_timing_mode_default,
-	};
+	u8 mode = chip->data_interface.timings.mode;
+	u8 tmode_param[ONFI_SUBFEATURE_PARAM_LEN] = { mode, };
 	int ret;
 
 	if (!nand_has_setup_data_iface(chip))
@@ -987,9 +986,9 @@ static int nand_setup_data_interface(struct nand_chip *chip, int chipnr)
 	if (ret)
 		goto err_reset_chip;
 
-	if (tmode_param[0] != chip->onfi_timing_mode_default) {
+	if (tmode_param[0] != mode) {
 		pr_warn("timing mode %d not acknowledged by the NAND chip\n",
-			chip->onfi_timing_mode_default);
+			mode);
 		goto err_reset_chip;
 	}
 
-- 
2.20.1


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/