[PATCH v6 04/19] spi: spi-mem: allow specifying a command's extension

[Pratyush Yadav <p.yadav@xxxxxx>]

In xSPI mode, flashes expect 2-byte opcodes. The second byte is called
the "command extension". There can be 3 types of extensions in xSPI:
repeat, invert, and hex. When the extension type is "repeat", the same
opcode is sent twice. When it is "invert", the second byte is the
inverse of the opcode. When it is "hex" an additional opcode byte based
is sent with the command whose value can be anything.

So, make opcode a 16-bit value and add a 'nbytes', similar to how
multiple address widths are handled.

Signed-off-by: Pratyush Yadav <p.yadav@xxxxxx>
---
 include/linux/spi/spi-mem.h | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/include/linux/spi/spi-mem.h b/include/linux/spi/spi-mem.h
index e3dcb956bf61..731bb64c6ba6 100644
--- a/include/linux/spi/spi-mem.h
+++ b/include/linux/spi/spi-mem.h
@@ -69,6 +69,8 @@ enum spi_mem_data_dir {
 
 /**
  * struct spi_mem_op - describes a SPI memory operation
+ * @cmd.nbytes: number of opcode bytes (only 1 or 2 are valid). The opcode is
+ *		sent MSB-first.
  * @cmd.buswidth: number of IO lines used to transmit the command
  * @cmd.opcode: operation opcode
  * @cmd.dtr: whether the command opcode should be sent in DTR mode or not
@@ -94,9 +96,10 @@ enum spi_mem_data_dir {
  */
 struct spi_mem_op {
 	struct {
+		u8 nbytes;
 		u8 buswidth;
 		u8 dtr : 1;
-		u8 opcode;
+		u16 opcode;
 	} cmd;
 
 	struct {
-- 
2.26.2


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/