Re: [PATCH v2 0/5] mtd: spi-nor: Add support for Octal 8D-8D-8D mode

[masonccyang@xxxxxxxxxxx]

Hi Pratyush,

> > > > I can't apply your patches to enable xSPI Octal mode for 
> > > > mx25uw51245g because your patches set up Octal protocol first and 
> > > > then using Octal protocol to write Configuration Register 2(CFG 
> > > > Reg2). I think driver
> > > > should write CFG Reg2 in SPI 1-1-1 mode (power on state) and make 
sure
> > > > write CFG Reg 2 is success and then setup Octa protocol in the 
last.
> > > 
> > > Register writes should work in 1S mode, because nor->reg_proto is 
only 
> > > set _after_ 8D mode is enabled (see spi_nor_octal_dtr_enable()). In 
> > > fact, both patch 15 and 16 in my series use register writes in 1S 
mode.
> > 
> > but I didn't see driver roll back "nor->read/write_proto = 1" 
> > if xxx->octal_dtr_enable() return failed!
> 
> I copied what spi_nor_quad_enable() did, and made failure fatal. So if 
> xxx->octal_dtr_enable() fails, the probe would fail and the flash would 
> be unusable. You can try your hand at a fallback system where you try 

IMHO, it's not a good for system booting from SPI-NOR, 
driver should still keep system alive in SPI 1-1-1 mode in case of 
enable Octal/Quad failed.

Therefore, my patches is to setup nor->read/write_proto = 8 in case 
driver enable Octal mode is success. And to enable Octal mode in
spi_nor_late_init_params()rather than as spi_nor_quad_enable()did.

> all possible protocols available, but I think that should be a different 

> patchset.
> 
> -- 
> Regards,
> Pratyush Yadav

thanks & best regards,
Mason

CONFIDENTIALITY NOTE:

This e-mail and any attachments may contain confidential information 
and/or personal data, which is protected by applicable laws. Please be 
reminded that duplication, disclosure, distribution, or use of this e-mail 
(and/or its attachments) or any part thereof is prohibited. If you receive 
this e-mail in error, please notify us immediately and delete this mail as 
well as its attachment(s) from your system. In addition, please be 
informed that collection, processing, and/or use of personal data is 
prohibited unless expressly permitted by personal data protection laws. 
Thank you for your attention and cooperation.

Macronix International Co., Ltd.

=====================================================================



============================================================================

CONFIDENTIALITY NOTE:

This e-mail and any attachments may contain confidential information and/or personal data, which is protected by applicable laws. Please be reminded that duplication, disclosure, distribution, or use of this e-mail (and/or its attachments) or any part thereof is prohibited. If you receive this e-mail in error, please notify us immediately and delete this mail as well as its attachment(s) from your system. In addition, please be informed that collection, processing, and/or use of personal data is prohibited unless expressly permitted by personal data protection laws. Thank you for your attention and cooperation.

Macronix International Co., Ltd.

=====================================================================


______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/